Results 131 to 140 of about 54,166 (309)
Fracture toughness testing of polymer matrix composites [PDF]
A review of the interlaminar fracture indicates that a standard specimen geometry is needed to obtain consistent fracture toughness measurements in polymer matrix composites.
Grady, Joseph E.
core +1 more source
Superior Impact‐Resistant Composite Hydrogels Through an Ionic Coupling Strategy
Advanced Materials, EarlyView.An ionic coupling strategy is developed to simultaneously reinforce networks and interfaces in composite hydrogels. Sodium citrate acts as a single multifunctional ionic coupler to strengthen the poly(vinyl alcohol) matrix via the Hofmeister effect, reinforce the chitosan–sodium alginate nanofiber network via desolvation and electrostatic crosslinking,
Hao Zhuo +5 more
wiley +1 more source
Advanced Materials, EarlyView.A transparent, deformable stevia–PVA hydrogel triboelectric nanogenerator delivers significantly enhanced mechanical strength and electrical output through biomimetic hydrogen‐bonded networks. Coupled with machine learning–assisted signal recognition, the self‐powered hydrogel enables accurate human‐motion sensing for intelligent wearable and IoT ...
Thien Trung Luu +5 more
wiley +1 more source
Fracture toughness determination and micromechanics of rock under mode I and mode II loading [PDF]
, 2005 Scientific Technical Report STR; 05 ...
openaire +3 more sources
Investigation on Mode I Fracture Toughness of Woven Carbon Fiber-Reinforced Polymer Composites Incorporating Nanomaterials. [PDF]
Polymers (Basel), 2020 Truong GT, Tran HV, Choi KK.
europepmc +1 more source
Advanced Materials Interfaces, EarlyView.This study presents the rational design and synthesis of a highly luminescent polymeric nanocomposite. Initially, highly fluorescent carbon quantum dots (CQDs) are synthesized via a facile hydrothermal method using citric acid and β‐alanine as precursors, followed by rigorous purification through centrifugation and filtration.
Yunus Emre Toprak +2 more
wiley +1 more source
Experimental investigation of the effects of water content on the anisotropy of mode I fracture toughness of bedded mudstones. [PDF]
PLoS One, 2020 Yang J, Li L, Lian H.
europepmc +1 more source
Hydrogel‐Based 3D‐Printable Stretchable Pressure Sensor
Advanced Materials Technologies, EarlyView.We present a carbon‐black‐functionalized double‐network granular hydrogel (DNGH) pressure sensor capable of detecting pressures from 200 Pa, equivalent to a light finger touch, up to 500 kPa. The sensor exhibits signal drifts below 3.5% after 800 cycles and response times around 80 ms. Leveraging this broad sensing range, we 3D print this material into
Tianyu Yuan +4 more
wiley +1 more source
Mode I Fracture Toughness of Polyamide and Alumide Samples obtained by Selective Laser Sintering Additive Process. [PDF]
Polymers (Basel), 2020 Stoia DI, Marsavina L, Linul E.
europepmc +1 more source
Advanced Materials Technologies, EarlyView.This study formulated a 5Y‐PSZ zirconia paste for extrusion‐based additive manufacturing via direct ink writing, producing dense ceramic structures for dental applications. A colloidal approach with 47 vol% nanometric powder and tailored additives optimized rheology and printability.
Juliana de Freitas Gouveia Silva +5 more
wiley +1 more source