Results 121 to 130 of about 87,595 (303)

Estimation of Longitudinal and Transverse Elastic Moduli of Native Brazilian Woods by Static Bending Tests

BioResources
Wood plays an essential role in civil construction due to its structural and sustainable properties. The longitudinal (E) and the transverse (G) modulus of elasticity are crucial for designing beams under bending, where combined deformations occur due to
Fabricio da Silva Aguiar, Guilherme dos Santos Silva, Herisson Ferreira dos Santos, Elvys Dias Reis, Francisco Antonio Rocco Lahr, André Luis Christoforo   +5 more
doaj  

Variation of the modulus of elasticity of aligner foil sheet materials due to thermoforming. [PDF]

J Orofac Orthop, 2022
Golkhani B, Weber A, Keilig L, Reimann S, Bourauel C.   +4 more
europepmc   +1 more source

Modulus of elasticity of reinforced silty sand

, 2011
Reinforced soil has been among the most effective soil modification materials. Its use has been expanded dramatically into civil engineering, geotechnical engineering and pavement engineering.
Nikraz, Hamid, Chegenizadeh, Amin
core  

Triple Junctions as Dislocation‐Like Defects: The Role of Grain Boundary Crystallography Revealed by Experiment and Atomistic Simulation

Advanced Engineering Materials, EarlyView.
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink, Saba Saood, Peter Schweizer, Jörg Neugebauer, Gerhard Dehm   +4 more
wiley   +1 more source

Elastic Modulus and Elasticity Ratio of Malignant Breast Lesions with Shear Wave Ultrasound Elastography: Variations with Different Region of Interest and Lesion Size. [PDF]

Diagnostics (Basel), 2021
Bulum A, Ivanac G, Divjak E, Biondić Špoljar I, Džoić Dominković M, Bojanić K, Lucijanić M, Brkljačić B.   +7 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

The Ratio between Static and Dynamic Modulusof Elasticity in Normal and High Strength Concrete

Journal of Engineering and Sustainable Development, 2006
There is a simple linear relationship between the static and dynamic elastic module, this lead to hope that using dynamic elastic modulus may remove the problems in measuring the static elastic modulus of concrete.
Mohammed M. Salman, Ali H. Al-Amawee
doaj  

Static Modulus of Elasticity Of Sand-Laterite Blocks

, 2014
There is little documentation with regards to some structural characteristics of masonry units. Inadequate information on these characteristics leaves room for much speculation, approximations and arbitrariness, which could be detrimental to the design ...
D. O. Onwuka, C. E. Okere, N. N. Osadebe
core  

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

Advanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky, Márk Sárközi, Ibolya Zsoldos, Zoltán Weltsch   +3 more
wiley   +1 more source

Analysis of bed joint influence on masonry modulus of elasticity

, 2014
The means of determining the modulus of elasticity presented in technical literature often underestimate factors such as the influence of mechanical properties of the bed joint mortar and the influence of contact zone of the masonry unit and mortar on ...
Lourenço, Paulo B., Jonaitis, B., Zavalis, R.   +2 more
core