Results 71 to 80 of about 1,903 (191)
Abstract Following an earthquake, faults lock and regain strength via a combination of healing mechanisms that include pressure solution, contact growth, and cementation. Fault healing dictates strength recovery during the seismic cycle and is therefore a key factor controlling earthquake recurrence intervals, stress drop, and other source properties ...
R. Affinito +5 more
wiley +1 more source
Deep‐Seated Landslide Stability on Curved Basal Surfaces With and Without Glacier Buttressing
Abstract Glacial retreat influences landslide dynamics, yet the controls on stability and transient acceleration remain unclear. We develop a two‐dimensional mechanical model of landslides with curved basal surfaces, Mohr‐Coulomb friction, and ice buttressing.
Rishav Mallick +2 more
wiley +1 more source
Generalised Kinematic Single‐Impact and Multi‐Impact Models for Rocking Structures
ABSTRACT The rocking motion is fundamental in earthquake engineering, as it reflects the dynamic behaviour of many structural systems. However, simulating the impacts during rocking motion remains a challenging topic, as they occur in a very short time, generate high impulsive forces, cause sudden changes in velocities and result in rapid energy losses.
Georgios Vlachakis +3 more
wiley +1 more source
Intrusion of wedge in the half-space under the Coulomb–Mohr yield criterion
The problem of wedge intrusion in the half-space was considered by R. Hill, E. Lie, and S. Tupper under the Mises yield criterion and Tresca yield criterion. In this case the perfect plastico-rigid body is incompressible.
A. N. Anisimov, A. I. Chromov
doaj +1 more source
Abstract California, located along the transform boundary between the Pacific and North American plates, hosts a complex fault system, a long history of damaging earthquakes, and frequent small earthquakes. While earthquakes arise from the buildup and release of elastic stress, detailed knowledge of principal stress orientations, absolute stress ...
Yifang Cheng +4 more
wiley +1 more source
This study presents a new interface for wellbore stability analysis, which visualizes and quantifies the stress condition around a wellbore at shear and tensile failure.
Jihoon Wang, Ruud Weijermars
doaj +1 more source
Abstract Melt migration in partially molten rocks is commonly described by porous flow models controlled by the hydro‐mechanical compaction length, which effectively explains melt extraction at mid‐ocean ridges. However, this framework cannot account for the paradoxical accumulation of small melt fractions into rhythmic leucosome–melanosome bands in ...
Qingpei Sun +3 more
wiley +1 more source
A Fractal-Enhanced Mohr–Coulomb (FEMC) Model for Strength Prediction in Rough Rock Discontinuities
Accurate prediction of the shear strength of rock discontinuities requires accounting for surface roughness, which is a factor neglected in the classical Mohr–Coulomb criterion.
Dina Kon +4 more
doaj +1 more source
To improve the resources’ recovery ratio and the economic benefits of open-pit mines, the development of highwall mining is used to exploit residual coal.
Rui Wang +4 more
doaj +1 more source
Abstract This study examined the spatiotemporal variability in geotechnical properties of beach cusp sediments on a sandy beach and tested if such variability can be used for cusp monitoring from satellite imagery. Specifically, sediment properties (including moisture content (w), relative density (Dr), sediment strength (QSBC) and friction angle (ϕ ...
Stephen Adusei +3 more
wiley +1 more source

