Results 1 to 10 of about 42,440 (269)
Micromachines, 2022 The high-purity G5 graphite material is widely used for glass moulding and provides high hardness and brittleness because it is sintered to fine particles unlike other graphite materials.
Hyeonhwa Lee +3 more
doaj +1 more source
Influence Evaluation of Tungsten Content on Microstructure and Properties of Cu-W Composite
Metals, 2022 At present, most studies focus on Cu-W composites with high W content (W content > 50 wt%), while there are only sporadic reports on Cu-W composites with low W content (W content < 50 wt%).
Xiuqing Li +10 more
doaj +1 more source
Two-Step Glass Molding Process for Forming Glass Edges with Obtuse Angles for Mobile Displays
Micromachines, 2022 The domain of edge displays with 2.5D or 3D curved designs has been expanded to improve user convenience. The currently available 3D cover glass offers a limited curvature radius of at least 5 mm and a curvature less than 88°, due to limitations in the ...
Jeongyeon Park +5 more
doaj +1 more source
Fibrous scaffold with a tunable nonlinear elasticity
Polymer Testing, 2021 Micro/nanofibers have been widely applied to mimic the fibrillary structure of collagen type I from a bionic point of view, however, the wavy structure of collagen fibers in biological tissues such as arteries and ligaments has hardly been fabricated. In
Xin Meng +6 more
doaj +1 more source
Applied Sciences, 2023 In this study, a multi-input, multi-output-based artificial neural network (ANN) was constructed by classifying output parameters into different groups, considering the physical meanings and characteristics of product quality factors in the injection ...
Junhan Lee, Jongsun Kim, Jongsu Kim
doaj +1 more source
Crystals, 2022 High chromium cast irons are commonly used as casting infiltration layers in the applications of wear resistance. The formation mechanism of the casting infiltration layer is essential to better develop the surface wear resistance materials using the ...
Chong Chen +9 more
doaj +1 more source
Study on rheological properties of in-mold co-injection self-reinforced polymer melt
Polymer Testing, 2021 The injection molding filling process is a complicated non-steady-state, non-isothermal non-Newtonian fluid flow process and heat transfer process. With the development of polymer melt pressure, temperature, shear rate and other physical quantities ...
Yong Lu, Kaiyu Jiang, Minjie Wang
doaj +1 more source
Simulation and Experimental Study on the Precision Molding of Irregular Vehicle Glass Components
Micromachines, 2023 The high level of stress and dimension deviation induced by glass molding are the main causes of the low yield rate of large, irregular glass components on vehicles.
Zhijun Chen +5 more
doaj +1 more source
Solubility and diffusion coefficient of supercritical CO2 in polystyrene dynamic melt
e-Polymers, 2020 The solubility and diffusion coefficient of supercritical CO2 in polystyrene (PS) dynamic melt were studied by using a new constant pressure experimental device.
Wang Long, Huang Xingyuan, Wang Duyang
doaj +1 more source
Crystals, 2021 Nanocellulose (NC) has been spotlighted as a new building block of future materials since it has many advantages, such as being lightweight and environment-friendly and having high mechanical properties and heat resistance.
Jung-Woong Kim +4 more
doaj +1 more source