Results 81 to 90 of about 102,118 (262)
Applicability of Microcellular Injection Molding for Thermoplastic Materials
, 2019 Tato bakalářská práce se zabývá vstřikováním termoplastických materiálů za pomoci technologie MuCell, namísto konvenčního vstřikování. Hodnocení aplikovatelnosti probíhalo na dvou procesních variantách. Posuzována byla vzniklá struktura vzhledem k úspoře
Rajnoha, Vojtěch
core +1 more source
Advanced Engineering Materials, EarlyView.This study examines Invar composites reinforced with titanium carbide (TiC) and titanium nitride (TiN) using laser powder bed fusion (LPBF). It presents the influence of reinforcements on microstructure, tensile properties, and thermal expansion. Results show that TiC effectively strengthens Invar while maintaining low thermal expansion, whereas TiN ...
Ayodeji Nathaniel Oyedeji +3 more
wiley +1 more source
What is the Difference Between Injection Molding vs Compression Molding?
, 2022 When it comes to manufacturing products, several different methods can be used: compression molding, injection molding, and extrusion. Not all molding processes are the same. Each of these methods has its unique benefits and drawbacks. In this blog post,
Alice
core +1 more source
Production of Liquid Metal Spheres by Molding
Metals, 2014 This paper demonstrates a molding technique for producing spheres composed of eutectic gallium-indium (EGaIn) with diameters ranging from hundreds of microns to a couple millimeters.
Mohammed G. Mohammed +2 more
doaj +1 more source
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Estudo de propriedades mecânicas e caracterização da região de linha de solda de um biopolímero injetado em molde metálico e molde de fabricação rápida (VRE) [PDF]
, 2013 Dissertação (mestrado) - Universidade Federal de Santa Catarina, Centro Tecnológico, Programa de Pós-Graduação em Engenharia Mecânica, Florianópolis, 2013.Um dos defeitos decorrentes do processo de injeção é a formação de linhas de solda, podendo ...
Pfeifer, Diogo Coletto
core
Advanced Engineering Materials, EarlyView.Gallium microalloying redirects interfacial reactions in low‐temperature Bi–Sn solders from Cu–Sn toward Cu–Ga intermetallic formation. The resulting Cu–Ga layer suppresses intermetallic growth during thermal aging, alters fracture pathways, and improves interfacial stability.
Iva Králová +6 more
wiley +1 more source
Dynamic of taking out molding parts at injection molding [PDF]
, 2012 Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it.
E. Ragan +4 more
core +3 more sources