Results 21 to 30 of about 5,846 (263)

Performance Enhancement of Direct Torque-Controlled Permanent Magnet Synchronous Motor with a Flexible Switching Table

open access: yesEnergies, 2020
In this paper, a flexible switching table (FST) for direct torque control (DTC) of permanent magnet synchronous motors (PMSMs) was proposed to enhance the steady-state and dynamic performances of the drive system.
Ahmed Nasr   +3 more
doaj   +1 more source

More Electricity in the Air: Toward Optimized Electrical Networks Embedded in More-Electrical Aircraft [PDF]

open access: yesIEEE Industrial Electronics Magazine, 2012
Along with the main trends and future challenges of electrical networks embedded in more-electrical aircraft, this article also focuses on optimization efforts in the field of industrial electronics and energy conversion. Optimization can be achieved by the means of expertise or from classical analysis methods, especially those based on simulations ...
Roboam, Xavier   +2 more
openaire   +4 more sources

Parameters Design and Optimization of SiC MOSFET Driving Circuit with Consideration of Comprehensive Loss and Voltage Stress

open access: yesMicromachines, 2023
In conventional parameters design, the driving circuit is usually simplified as an RLC second-order circuit, and the switching characteristics are optimized by selecting parameters, but the influence of switching characteristics on the driving circuit is
Haihong Qin   +5 more
doaj   +1 more source

Review of More Electric Engines for Civil Aircraft

open access: yesInternational Journal of Aeronautical and Space Sciences, 2022
More electric engines (MEEs) and more electric aircraft are mainly implemented to address the global warming issue and make engines more fuel efficient. Developing technology has made them applicable. This paper presents a detailed introduction to the MEE for civil aircraft, including its architecture, characteristics and performance, as well as the ...
Yixiong Liu   +4 more
openaire   +3 more sources

A Scalable System Architecture for High-Performance Fault Tolerant Machine Drives

open access: yesIEEE Open Journal of the Industrial Electronics Society, 2021
When targeting mission critical applications, the design of the electronic actuation systems needs to consider many requirements and constraints not typical in standard industrial applications.
Filippo Savi   +4 more
doaj   +1 more source

Overview and analysis of PM starter/generator for aircraft electrical power systems

open access: yesCES Transactions on Electrical Machines and Systems, 2017
More Electrical Aircraft (MEA) which replaces the hydraulic and pneumatic power by electrical power leads to reducing emissions and fuel consumption. The MEA concept has led to a growing use of the starter/generator (S/G) system.
Zhuoran Zhang   +4 more
doaj   +1 more source

Optimal Area-Product Model (OAPM) Based Non-Iterative Analytical Design Methodology for Litz-Wired High-Frequency Gapped- Transformer (LHFGT) in LLC Converters

open access: yesIEEE Access, 2020
In dc-dc LLC resonant converters, the Litz-wired high-frequency gapped-transformer (LHFGT) plays an important role, as it provides the necessary isolation, the required voltage-conversion, and the desired magnetizing inductance (Lm) for efficient ...
Daniyal Ahmed, Li Wang
doaj   +1 more source

Series Arc Detection and Complex Load Recognition Based on Principal Component Analysis and Support Vector Machine

open access: yesIEEE Access, 2019
The increasing household loads make series arc faults more complex, which are difficult to be detected by traditional circuit breakers and lead to the frequent occurrence of residential fire accidents.
Jun Jiang   +6 more
doaj   +1 more source

Stability Analysis of Two-Stage Single-Phase Converter System Adopting Electrolytic Capacitor-Less Second Harmonic Current Compensator

open access: yesIEEE Open Journal of the Industrial Electronics Society, 2021
For the two-stage single-phase converter, including the power factor correction (PFC) ac-dc converter and dc-ac inverter, a second harmonic current compensator (SHCC) can be introduced to handle the second harmonic current (SHC) for removing the ...
Xinze Huang, Xinbo Ruan
doaj   +1 more source

Reliability-Oriented Design of Inverter-Fed Low-Voltage Electrical Machines: Potential Solutions

open access: yesEnergies, 2021
Transportation electrification has kept pushing low-voltage inverter-fed electrical machines to reach a higher power density while guaranteeing appropriate reliability levels. Methods commonly adopted to boost power density (i.e., higher current density,
Yatai Ji   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy