Results 151 to 160 of about 2,741 (253)
Rhizobacterial inoculation of barley reduced Sitobion avenae populations by inducing plant resistance and modifying volatiles that attracted parasitoid wasps earlier, enhancing both bottom‐up and top‐down pest control. Abstract BACKGROUND Soil rhizobacteria can enhance crop resistance to insect herbivores and influence higher trophic interactions ...
Megan E Parker +2 more
wiley +1 more source
Modeling and Optimization for Morphing Wing Concept Generation
This report consists of two major parts: 1) the approach to develop morphing wing weight equations, and 2) the approach to size morphing aircraft. Combined, these techniques allow the morphing aircraft to be sized with estimates of the morphing wing ...
Skillen, Michael D. +1 more
core
Personalised Perception: The Effect of Personality on the Sensory Effects of Psychedelics
ABSTRACT Introduction Psychedelics induce a wide range of sensory distortions and hallucinations (henceforth ‘distortions’). Yet, little is known about factors that influence the occurrence of certain distortions. Extra‐pharmacological variables including personality traits have been found to correlate with the occurrence of different subjective ...
Alexander Boardman +2 more
wiley +1 more source
Actuation System Design for a Morphing Wing Trailing Edge
Shape control of adaptive wings has the potential to improve aircraft aerodynamic performance during cruise. In recent years, several patents have been issued for inventions in the field of morphing wings, using hydraulic, electromechanical or smart ...
Ignazio Dimino +4 more
core +1 more source
Drought Stress Promotes Aphis gossypii Growth but Decreases Host Attractiveness in Melon
ABSTRACT Drought stress is a significant environmental factor that affects plant physiology and growth, leading to considerable detrimental effects on crop productivity. Cucumis melo, which is widely cultivated for its economic value, is particularly susceptible to water scarcity.
G. Clemente‐Orta +4 more
wiley +1 more source
Morphing wing with skin discontinuity – kinematic concept
Purpose This paper aims to describe the concept of morphing tailless aircraft with discontinuous skin and its preliminary kinematic solution. Project assumptions, next steps and expected results are briefly presented.
Andrzej Tarnowski
core +1 more source
Development of Vertical Wind Turbine Blades Using 4D Printing of Composites
Vertical axis wind turbine: White blade: Commercial. Black blade: Composite. ABSTRACT This paper presents the procedure to make vertical wind turbine blades using the technique of 4D printing of composites (4DPC). The blades are made using carbon/epoxy composite materials with a fiber volume fraction of about 60%.
Emad Fakhimi, Suong Van Hoa
wiley +1 more source
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Vacuum–Laser Fabrication of Programmable Soft Actuators
A rapid and accessible fabrication strategy for inflatable soft actuators is presented, combining vacuum sealing with laser cutting of low‐cost thermoplastic pouches. The method enables precise sealing, fast fabrication, and programmable multi‐cell geometries.
Ashkan Rezanejad +5 more
wiley +1 more source
New Insights Into Cranial Base Ontogeny in Modern Humans Through Morphometric Analysis
ABSTRACT Objectives The cranial base is located at the interface between the face, the brain, and the vertebral column. Understanding its growth is essential for elucidating key aspects of craniofacial development, neurodevelopment, and locomotor function.
Amaëlle Sourbé +3 more
wiley +1 more source

