Results 191 to 200 of about 1,051,039 (302)

Chemical, optical, and morphological properties of TPU and PET-G samples after aging in artificial saliva: an in vitro study. [PDF]

BMC Oral Health
Staderini E, Chiusolo G, Papi M, Palone M, Lombardo L, Cordaro M.   +5 more
europepmc   +1 more source

Studies on the Effect of the Addition of Nano-Spherical Particles of Aluminum on the Thermal, Mechanical, and Morphological Properties of PBT-PET Blend Composites. [PDF]

Polymers (Basel), 2023
Alhamidi A, Anis A, Bashir Z, Alam MA, Al-Zahrani SM.   +4 more
europepmc   +1 more source

On‐Demand Activation of Thin Alginate Shell Encapsulated Volatile Liquid for Untethered Pneumatic Soft Actuation

Advanced Engineering Materials, EarlyView.
Phase‐changing liquids enable untethered pneumatic actuation in soft robotics but suffer from volatility and storage challenges. This work reports a simple method to encapsulate Novec 7000 within micron‐thin alginate shells via in situ injection and ionic crosslinking.
Rayan A. M. Basodan, Jack Keddie, Byoungyoul Park, Hyun‐Joong Chung   +3 more
wiley   +1 more source

Analysis of the Influence of Manufacturing Technology on Selected Static, Fatigue and Morphological Properties of CFRP Composites. [PDF]

Materials (Basel)
Kubit A, Debnath K, Slota J, Dominik F, Dubey AD, Rao GS, Żaba K.   +6 more
europepmc   +1 more source

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Controllable synthesize of ZnS/PbS nanostructure and their structural and morphological properties. [PDF]

Heliyon
Assfour B, Abadllah B, Daoud N, Kakhia M, Zetoun W.   +4 more
europepmc   +1 more source

Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena, Benjamin Bergmann, Michael Zenger   +2 more
wiley   +1 more source

Enhancement of Diffusion-Controlled Pseudocapacity in Biphasic NaMnO _<b>2</b> Electrodes for Sodium Batteries by Tailoring Structural and Morphological Properties. [PDF]

ACS Omega
Boichuk A, Boichuk T, Kreĉmarová M, Eledath Changarath M, Abargues R, Agouram S, Sánchez-Royo JF.   +6 more
europepmc   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

The Influence of Mixed Powder Ageing on the Structural, Chemical, and Crystalline Morphological Properties of the PA12 Used to Manufacture Laser Sintering. [PDF]

Polymers (Basel)
García Rodríguez A, Espejo Mora E, Velasco Peña MA, Narváez Tovar CA.   +3 more
europepmc   +1 more source