Results 11 to 20 of about 98,659 (257)
Preparation and Properties of Masonry Mortar from Spontaneous Combustion Coal Gangue
Medžiagotyra, 2023 To solve the problem of gangue stockpiling, this paper intends to study the feasibility of preparing masonry mortar based on spontaneous combustion gangue.
Wenqing MENG +4 more
doaj +1 more source
Acceleration of Early Strength Development in Mortars Containing Soluble Silica Extracted from Palm Oil Clinker [PDF]
Archives of Metallurgy and MaterialsSoluble silica from palm oil clinker was extracted using Laine’s method. It involved two major steps, namely water reflux and distillation. The use of 480 g of POCP and 12 hours of distillation in the extraction experiment resulted in 53.50% of dissolved
A.H. Ismail +4 more
doaj +1 more source
Results in Engineering, 2023 The use of steel fillers enhances the flexural behaviour of mortar and concrete. However, it makes it more difficult to disperse them uniformly and coat them firmly in the mortar/concrete with the conventional mixing method while using them at higher ...
Tek Raj Gyawali
doaj +1 more source
Evaluation of mechanical behaviour of the rubberized PCC mortar in fixed W/C ratio
Cogent Engineering, 2020 Addition of the waste tire rubber powder to the cement-based products is a solution for the waste problems and protecting environment. Cement-sand mortar is an integral part of masonry buildings and has an important effect on the integrity of the masonry
Mahdi Adibi +2 more
doaj +1 more source
Bond strength of alkali-activated flyash based masonry system for sustainable construction
SN Applied Sciences, 2023 Bond strength is a crucial factor that impacts the performance, structural reliability and stability of masonry constructions. This paper aims to examine the efficacy of various masonry unit and mortar combinations and their bond strength thereby ...
Pooja Kumble +2 more
doaj +1 more source
Journal of Civil Engineering and Management, 2012 To prevent excessive air entrainment, superplasticizers (SPs) should not only be compatible with cement, but also should not create the air-entraining effect in mortar.
Beata Łazniewska-Piekarczyk +1 more
doaj +1 more source
RESISTANCE OF MORTARS WITH GYPSUM, LIME AND COMPOSITE BINDERS AGAINST MOLDS
Acta Polytechnica CTU Proceedings, 2019 Resistance of three mortars (the lime mortar, the gypsum mortar and the mortar with the composite binder) against molds was evaluated. Mortars were also compared according to their pH, bulk density, strength and porosity. Experiments showed that the lime
Jitka Krejsová, Magdaléna Doleželová
doaj +1 more source
Mechanical Properties and Microscopic Mechanism of Coral Sand-Cement Mortar
Advances in Materials Science and Engineering, 2020 The workability and mechanical performance of coral sand-cement mortar (coral mortar, for short) and the modification effects of mineral admixtures on the coral mortar were studied in this paper.
Luoxin Wang +5 more
doaj +1 more source
The Scientific World Journal, 2014 This paper investigates the physicomechanical properties of mortar containing high volume of fly ash (FA) as partial replacement of cement in presence of copolymer latexes.
El-Sayed Negim +5 more
doaj +1 more source
Characteristics and Design of Inong Balee Fort Binding Mortar For Restoration Purposes
Elkawnie: Journal of Islamic Science and Technology, 2020 : Inong Balee Fort is one of the Islamic Kingdom of Aceh heritage built in 1599 by Admiral Malahayati but several parts of the fortress wall have currently been damaged and the stone removed. Indonesian Government plans to restore the fort and this makes
Muttaqin Hasan +2 more
doaj +1 more source