Electrical properties of mechanically activated zinc oxide [PDF]
Microstructural properties of a commercial zinc oxide powder were modified by mechanical activation in a high-energy vibro-mill. The obtained powders were dry pressed and sintered at 1100°C for 2 h.
Branković G. +3 more
core +1 more source
Balancing Electrons to Break the Activity‐Selectivity Trade‐Off in H2O2 Electrosynthesis
Carrier‐concentration balancing in CuS is achieved by coupling cobalt dopants with cobalt vacancies, converting CuS from p‐ to n‐type to accelerate 2e− ORR while withdrawing excess carriers to optimize *OOH binding for H2O2 desorption. The catalyst reaches 8.14 mol g−1 h−1 with >84% selectivity in 1.0 M KOH and drives robust electro‐Fenton dye ...
Hangning Liu +11 more
wiley +1 more source
A cross‐layer passivation strategy employing molecularly designed thiazol‐5‐ylmethanamine hydrochloride (TMACl) enables coherent defect regulation at the SnO2/perovskite interface, stabilizes both layers, promotes phase‐pure α‐FAPbI3 formation, and enhances charge extraction, delivering PCEs of 26.44% in rigid and 24.72% in flexible perovskite solar ...
Fan Shen +16 more
wiley +1 more source
Boosting selective nitrogen reduction to ammonia on electron-deficient copper nanoparticles
Production of ammonia is currently realized by the Haber–Bosch process, while electrochemical N2 fixation under ambient conditions is recognized as a promising green substitution in the near future.
Antonietti, M. +9 more
core +1 more source
Photoelectrochemical behavior of electrophoretically deposited hematite thin films modified with ti(IV) [PDF]
: Doping hematite with different elements is a common strategy to improve the electrocatalytic activity towards the water oxidation reaction, although the exact effect of these external agents is not yet clearly understood.
Argazzi, Roberto +9 more
core +2 more sources
Opportunities of Semiconducting Oxide Nanostructures as Advanced Luminescent Materials in Photonics
The review discusses the challenges of wide and ultrawide bandgap semiconducting oxides as a suitable material platform for photonics. They offer great versatility in terms of tuning microstructure, native defects, doping, anisotropy, and micro‐ and nano‐structuring. The review focuses on their light emission, light‐confinement in optical cavities, and
Ana Cremades +7 more
wiley +1 more source
Electrochemical and Photoelectrochemical Investigation of Water Oxidation with Hematite Electrodes [PDF]
Atomic layer deposition (ALD) was utilized to deposit uniform thin films of hematite (α-Fe2O3) on transparent conductive substrates for photocatalytic water oxidation studies.
Abdi F. F. +55 more
core +4 more sources
In Situ Amine Formation to Modulate MOF‐Derived PdIn N‐Doped Carbon Catalysts
An amine‐assisted approach converts PdIn‐MOF into PdIn intermetallic nanoparticles embedded in N‐doped carbon. In situ‐generated amines trigger early Pd nucleation, producing smaller PdIn domains than direct pyrolysis. Amine sterics and basicity tune composition and particle size, while solvent and amine co‐determine textural features.
Gonzalo Egea +9 more
wiley +1 more source
Corrosion resistance of 316L stainless steel in fuel cell electrolyte
The corrosion resistance and semiconductors of passivation film on the surface of 316L stainless steel has been explored using linear polarization,Potentiostatic polarization electrochemical impedance spectroscopy (EIS) and Mott–Schottky analysis in 0,1 /
T. T. Chen, S. M. Kang, Y. L. Li
doaj
Mott–Schottky Analysis of SnO2 Nanoparticles by Impedance Measurements underUltrahigh Pressure [PDF]
In this study, the SnO2 nanoparticle powders were compacted into a disk shape form of under a ultrahigh pressure up to 49.6 GPa. Complex impedance analysis of nano-SnO2 thick film/electrode system was studied as a function of applied potential.
Chenari, H.M.
core

