Development and characterisation of injection moulded, all-polypropylene composites [PDF]
, 2012 In this work, all-polypropylene composites (all-PP composites) were manufactured by injection moulding. Prior to injection moulding, pre-impregnated pellets were prepared by a three-step process (filament winding, compression moulding and pelletizing).
Bárány, Tamás +3 more
core +2 more sources
Les moulages de Notre-Dame de Laon : une découverte récente
In Situ, 2016 In 2012, during the preparation of the exhibition entitled ‘Notre-Dame de Laon. Des ruines romantiques au renouveau gothique’, forty plaster casts from the nineteenth-century restoration period were discovered.
Caroline Dujon-Attali Ben Mayer
doaj +1 more source
Les figurines de Tarse. Partie II. Étude technique : mise en œuvre du moulage et de la polychromie
Pallas, 2023 The material study of a corpus of twenty-two figurines from Tarsus was carried out in parallel with analyses of terracotta and polychromy. It was based on systematic observations under visible light and raking light, as well as on ultraviolet induced ...
Clara Bernard, Julie Abbou
doaj +1 more source
Current Biology, 2010 New studies suggest the extent to which fungi are local to their indoor habitats.
openaire +2 more sources
The Compositions: Biodegradable Material – Synthetic Resins as Moulding Sands Binders
Archives of Foundry Engineering, 2016 Growing emission requirements are forcing the foundry industry to seek new, more environmentally friendly solutions. One of the solutions may be the technologies of preparing moulding and core sands using organic biodegradable materials as binders ...
Major-Gabryś K. +2 more
doaj +1 more source
IET Optoelectronics, 2022 With the emergence of the different light‐emitting diode (LED) packaging materials, the thermal analysis of LED device packaging with different materials has become urgent. The thermal performance of LED packaging with a poly(1,4‐cyclohexylenedimethylene
Dezhi Zhao +3 more
doaj +1 more source
Analysis of rheological behaviour of titanium feedstocks formulated with a water-soluble binder system for powder injection moulding [PDF]
, 2014 Binder selection and formulation are critical in powder injection moulding. Binders play a key role in controlling the rheological properties of a feedstock and influence whether the resulting feedstock can be successfully injection moulded, debound and ...
Cao, Peng +3 more
core +2 more sources
Real-time diagnostics of gas/water assisted injection moulding using integrated ultrasonic sensors [PDF]
, 2007 YesAn ultrasound sensor system has been applied to the mould of both the water and gas assisted injection moulding processes. The mould has a cavity wall mounted pressure sensor and instrumentation to monitor the injection moulding machine.
Brown E. C. +17 more
core +2 more sources
Conserver, restaurer et transmettre : le cas des sculptures en marbre des jardins de Versailles
Bulletin du Centre de Recherche du Château de Versailles, 2019 Created predominantly by the will of Louis XIV, the immense sculptural legacy of the gardens of Versailles is made up of more than one thousand works. Its implementation was a part of political and cultural factors that made Versailles a new Rome. Within
Alexandre Maral
doaj +1 more source
Humidity Migration in Surface Layers of Sand Moulds During Processes of Penetration and Drying of Protective Coatings [PDF]
Archives of Foundry Engineering, 2022 The results of investigations of humidity migration in near surface layers of sand mould during processes of penetration and drying of protective coatings are presented in the hereby paper.
Ł. Jamrozowicz, J. Zych
doaj +1 more source