Results 141 to 150 of about 19,896 (196)

Erratum to "Movement Disorder Perspectives at MCT8 Deficiency: A Case Series of Three Colombian Patients With Allan Herndon Dudley Syndrome". [PDF]

Mov Disord Clin Pract
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

An MoV monophosphate, Rb2Mo2P2O11

Acta Crystallographica Section C Crystal Structure Communications, 1994
Molybdenum rubidium phosphate, Rb 2 Mo 2 P 2 O 11 , has been synthesized and the growth of single crystals allowed its structure to be determined. This compound is isotypic with Tl 2 Mo 2 P 2 O 11 and K 2 Mo 2 P 2 O 11 , and contains a framework built from Mo 2 P 2 O 15 units formed by one Mo 2 O 11 group sharing four of its corners with two PO 4 ...
A. Guesdon, A. Leclaire, M. M. Borel, A. Grandin, B. Raveau   +4 more
openaire   +1 more source

Increasing the reliability of MOV arresters

IEEE Transactions on Power Delivery, 1990
A shunt-gap module is designed for use in metal-oxide surge arresters to increase their tolerance to temporary system overvoltages and to lower the protective response. These are conflicting design objectives in current gapless metal-oxide-varistor (MOV) construction.
A.C. Westrom, S.W. Law
openaire   +1 more source

Investigation on the equivalent circuit for MOV

IEEE/PES Transmission and Distribution Conference and Exhibition, 2003
The current response for MOV under the step voltages with different amplitudes has been investigated in this paper. A more practical equivalent circuit in the whole current region and the method to determine its corresponding circuit parameters is proposed according to the phenomena that the MOV has polarized current in a low current region and has ...
null Yuanfang Wen, null Xianglian Yan, null Xiaoyu Yi, null Yujing Liang, null Yuyi Zhao   +4 more
openaire   +1 more source

Application of MOVs in the distribution environment

IEEE Transactions on Power Delivery, 1994
The introduction of the MOV (metal oxide varistor) arrester for distribution systems followed the successful use of these arresters in the transmission area. Higher than expected failure rates for these arresters have brought up the question of whether most of these failures are caused by system conditions related to poor application methods or by poor
T.A. Short, J.J. Burke, R.T. Mancao
openaire   +1 more source

A method for the lifetime prediction of MOV

Proceedings of 2001 International Symposium on Electrical Insulating Materials (ISEIM 2001). 2001 Asian Conference on Electrical Insulating Diagnosis (ACEID 2001). 33rd Symposium on Electrical and Electronic Insulating Materials and Applications in System, 2002
On the basis of a number of the multi-stress aging experimental analysis, by means of the characteristic points of the resistive leakage current-time curves and by using the similarity condition, a method for the lifetime prediction of MOV is presented in this paper.
null Wen Yuanfang, null Yan Xianglian, null Liu Chun   +2 more
openaire   +1 more source

New MOV Failure Mode Identification Invention

IEEE Transactions on Consumer Electronics, 2007
This patent pending technology relates, generally, to surge protection devices. More particularly, it relates to a surge protection device that relies on the capacitive properties of the metal oxide varistor (MOV) as a part of an impedance network for failure identification.
Stelios G. Ioannou, Elias K. Stefanakos, Paris H. Wiley   +2 more
openaire   +1 more source

Movie_2_1.mov

2023
openaire   +1 more source

Effect of Heat Treatment on Microstructure and Properties of Improved 40CrNi2Si2MoV Steel

Steel Research International, 2023
Kejian Li, Yuanshou Tang
exaly