Results 11 to 20 of about 25,700 (297)
Rare-earth Element doped YSZ/YSZ Multilayer Thermal Barrier Coating with High Infrared Reflectivity
Journal of Aeronautical Materials, 2018 The operating temperature of advanced aeroturbine engine increases rapidly for higher working efficiency. Thermal barrier coatings (TBCs) with high temperature capability and thermal insulation effect are required.
YANG Wei, WANG Yufeng
doaj +2 more sources
Wear resistant multilayer nanocomposite WC1−x/C coating on Ti–6Al–4V titanium alloy [PDF]
, 2015 A significant improvement of tribological properties on Ti–6Al–4V has been achieved by developed in this study multilayer treatment method for the titanium alloys.
Mathia, T.G. +7 more
core +1 more source
Protection of Zr Alloy under High-Temperature Air Oxidation: A Multilayer Coating Approach [PDF]
, 2021 Metallic Cr and multilayer CrN/Cr coatings with a thickness of 2.5 µm were deposited onto E110 alloy by magnetron sputtering. Oxidation tests in air were performed at 1100 °C for 10-40 min. The gravimetric measurements showed better protective properties
Ruchkin, Sergey Evgenjevich +9 more
core +1 more source
Measurement of Thermo-Optic Properties of Thin Film Dielectric Coatings [PDF]
, 2013 We have carried out an experiment to test the theory of the thermo-optic response of a dielectric stack mirror coating and to measure parameters of interest in calculating thermo-optic noise. Specifically, we measured the coefficient of thermal expansion
Ogin, Gregory H.
core +1 more source
Protective multilayer CrN/Cr coating for zirconium alloys [PDF]
, 2021 Metallic Cr and multilayer CrN/Cr coatings with a thickness of 2.5 µm were deposited onto E110 alloy by magnetron sputtering. Uniform and thinner oxide layers of Zr alloy are observed when the multilayer coatings are applied.
Пирожков, А. В. +1 more
core
Synthesis and tribocorrosion performances of multilayer (Ta/ZrN)n coatings [PDF]
, 2022 Multilayer thin coatings (~3 µm in thickness) were deposited using reactive radio frequency magnetron sputtering on Ti-6Al-4 V substrate for biomaterial applications.
NASSER EDDINE, BELIARDOUH +5 more
core +1 more source
Biological responses to multilayered DNA‐coatings [PDF]
Journal of Biomedical Materials Research Part B: Applied Biomaterials, 2006 AbstractThis study was performed to evaluate the basic biological response to deoxyribonucleic acid (DNA)‐based coatings for soft tissue implants. To that end, in vitro experiments were used to study their cytocompatibility, and in vivo subcutaneous implantation studies with transponders in a rat model were performed to evaluate their ...
Beucken, J.J.J.P van den +5 more
openaire +2 more sources
Nihon Kikai Gakkai ronbunshu, 2019 In our previous study, it was found that the wear life of the DLC/AlN multilayer hybrid coating could be improved by approximately 80 times of that of a DLC film deposited directly onto an aluminum (Al)-alloy.
Masashi NAKAMURA, Tsutomu ISHII
doaj +1 more source
Bioactive Materials, 2020 Magnesium alloy is considered as one of the ideal cardiovascular stent materials owing to its good mechanical properties and biodegradability. However, the in vivo rapid degradation rate and the insufficient biocompatibility restrict its clinical ...
Fan Gao +7 more
doaj +1 more source
Evaluation of the Multi-Structural Potential of Ni-Co/SiC Nanocomposite Coatings Electrodeposited in API 5L X80 Steel [PDF]
Materials Research, 2021 The use of nanocomposite coatings on carbon steel has been very promising. In this paper, the formation mechanism of multilayer of Ni-Co/SiC nanocomposite coating electrodeposited in API 5L X80 steel was investigated.
Roseana F. da C. Pereira +3 more
doaj +1 more source