Results 51 to 60 of about 48,799 (310)
Annual Conference of the IEEE Industrial Electronics Society, 2019 Multiphase induction machines have the advantage of producing torque under different current harmonics. Theoretically, with some simplifications, the maximum produced torque can be considered proportional to the harmonic winding factor related to the ...
Abdelhak Mekahlia +3 more
semanticscholar +1 more source
IEEE Transactions on Industry Applications, 2023 In the recent literature, a rewinding approach was proposed to construct a rewound five-phase machine with either star-connected or combined star-pentagon winding using existing off-the-shelf three-phase stator frames. The power per phase drops by a factor of 3/5 in the five-phase machine compared to the three-phase machine.
Kotb B. Tawfiq +4 more
openaire +1 more source
A comprehensive analysis of SVPWM for a Five-phase VSI based on SiC devices applied to motor drives [PDF]
, 2019 © 2019 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes,creating new ...
Acosta Cambranis, Fernando Geovany +2 more
core +1 more source
Energy Reports, 2022 A robust control scheme of a wind turbine system (WTS) based on a dual star induction generator (DSIG) in normal and open-phase fault (OPF) mode is presented in this paper.
Abdelkader Guettab +3 more
doaj +1 more source
Open-phase fault operation on multiphase induction 3 motor drives [PDF]
, 2015 Hugo Guzman, Ignacio Gonzalez, Federico Barrero and Mario Durán (2015). Open-Phase Fault Operation on Multiphase Induction Motor Drives, Induction Motors - Applications, Control and Fault Diagnostics, Dr.
Barrero, Federico +5 more
core
Multiphase PMSM and PMaSynRM flux map model with space harmonics and multiple plane cross harmonic saturation [PDF]
, 2019 © 2019 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes,creating new ...
Acosta Cambranis, Fernando Geovany +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Impact of PWM strategies on RMS current of the DC-link Voltage Capacitor of a dual-three phase drive [PDF]
, 2014 The major drawback of usual dual three-phase AC machines, when supplied by a Voltage Source Inverter (VSI), is the occurrence of extra harmonic currents which circulate in the stator windings causing additional losses and constraints on the power ...
DUGUEY, Jean-François +2 more
core +4 more sources
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Effect of Winding Configuration on Six-Phase Induction Machine Parameters and Performance
IEEE Access, 2020 Six-phase induction machines have mostly shown promise in high-power electric drive applications as well as wind energy conversion systems. Different winding configurations for six-phase stators have been published, namely, dual three-phase (D3P ...
Ayman S. Abdel-Khalik +2 more
doaj +1 more source