Results 11 to 20 of about 11,686 (251)
Multiple-input multiple-output over-the-horizon radar: experimental results
Results from an experiment that applied one class of multiple-input multiple-output (MIMO) waveform techniques to over-the-horizon radar (OTHR) are reported. The experiment objective was to demonstrate that adaptive transmitter beamforming could be used in an appropriately design radar to reject spatially discrete Doppler-spread clutter.
Y I Abramovich, B A Johnson
exaly +2 more sources
Target localisation techniques and tools for multiple-input multiple-output radar
This study presents a comparative study of coherent and non-coherent target localisation techniques for multiple-input multiple-output (MIMO) radar systems with widely distributed elements. Performance is evaluated based on closed-form solutions developed for the best linear unbiased estimator (BLUE) for each of the localisation methods.
R S Blum
exaly +2 more sources
Target Localization and Tracking in Noncoherent Multiple-Input Multiple-Output Radar Systems
For a noncoherent multiple-input multiple-output (MIMO) radar system, the maximum likelihood estimator (MLE) of the target location and velocity, as well as the corresponding Cramer-Rao lower bound (CRLB) matrix, is derived. MIMO radar's potential in localization and tracking performance is demonstrated by adopting simple Gaussian pulse waveforms.
Rick S Blum +2 more
exaly +3 more sources
A review of orthogonal waveforms for spaceborne Multiple-Input Multiple-Output Synthetic Aperture Radar [PDF]
Spaceborne Multiple-Input Multiple-Output Synthetic Aperture Radar (MIMO-SAR) overcomes fundamental shortcomings of state-of-the-art SAR, such as the trade-off between swath width and spatial resolution, and offers a greater agility of the antenna beam ...
T. Rommel, M. Younis, M. Chandra
doaj +3 more sources
Multiple-Input Multiple-Output Microwave Tomographic Imaging for Distributed Photonic Radar Network
This paper deals with the imaging problem from data collected by means of a microwave photonics-based distributed radar network. The radar network is leveraged on a centralized architecture, which is composed of one central unit (CU) and two transmitting
Carlo Noviello +8 more
doaj +2 more sources
Multiple-input multiple-output radar detectors design in non-Gaussian clutter
This study mainly deals with the problem of multiple-input multiple-output (MIMO) radar in compound-Gaussian clutter-dominated scenario with unknown covariance matrix. The general MIMO model, with widely separated sub-arrays and co-located antennas at each sub-array, is adopted.
G. Cui, L. Kong, X. Yang
exaly +2 more sources
Real-Time Multiple Input Multiple Output (MIMO) Radar Using Software Defined Radio [PDF]
In this paper, commercially-available software-defined radios (SDRs) are used to build a 64-channel, reconfigurable Active Electronically Scanned Arrays (AESA) radar operating in C-band (NATO G-band).
Gilpin Robert +2 more
doaj +1 more source
This study discusses the integrated system of full‐duplex (FD) multiple‐input‐multiple‐output (MIMO) communication and MIMO radar, which has been rarely considered in published studies.
Shengnan Shi, Zishu He, Ziyang Cheng
doaj +1 more source
Ultra wideband multiple-input multiple-output radar [PDF]
The utilization of ultra wideband (UWB) signals enables the radar designer to solve the most important problems of radar target observation. The extremely wide bandwidth enables greater information to be obtained due to high time resolution and the frequency dependence of the scattering centers over this large bandwidth.
H.A. Khan +3 more
openaire +1 more source
The performances of a multiple-input multiple-output (MIMO) radar, employing 16 equivalent antennas, and multiple-input single-output (MISO) radar, employing 10 antennas, for through-the-wall imaging applications are analyzed.
Stefano Pisa +3 more
doaj +1 more source

