Results 91 to 100 of about 1,209,937 (298)
Wood‐Derived Nanocellulose‐Biocarbon Fresnel‐Zone Plate Lenses for Sub‐THz Frequency Applications
Advanced Materials Technologies, EarlyView.Wood‐derived nanocellulose and lignin‐based biocarbon were combined to fabricate fully bio‐based Fresnel zone plate (FZP) lenses for sub‐terahertz frequencies. These sustainable FZP lenses exhibit low dielectric loss and high directivity, achieving performance comparable to that of metallic references, and remain functional under environmental stress ...
Riikka Haataja +9 more
wiley +1 more source
, 2021 Meltblown fabric vs nanofiber membrane, which is better for fabricating personal protective ...
Z Zhong (6469679) +8 more
core
Advanced Materials Technologies, EarlyView.Transparent microelectrode arrays enable simultaneous optical and electrical electrophysiology with high spatiotemporal resolution, allowing multimodal observations of dynamic biological systems. Advances in materials and device architectures improve device performance by addressing key trade‐offs between optical transparency, impedance, and ...
Michael Abraham Listyawan +6 more
wiley +1 more source
W5ater desalination using graphene-enhanced electrospun nanofiber membrane via air gap membrane distillation [PDF]
, 2016 © 2016 This study demonstrates the preparation and desalination performance via air gap membrane distillation (AGMD) of a graphene-loaded electrospun nanofiber membrane.
Choi, JS +15 more
core +1 more source
Advanced Materials Technologies, EarlyView.This review summarizes moisture‐adaptive strategies that enable triboelectric nanogenerators (TENGs) to operate across diverse moisture conditions. It examines moisture‐management methods, including exclusion, directional transport, removal, and utilization, with charge‐regulation approaches based on interfacial, dielectric, and structural engineering.
Junzhe Gan +4 more
wiley +1 more source
, 2023 High-temperature polymer-electrolyte membrane fuel cells (HT-PEM FC) are a very important type of fuel cell since they operate at 150–200 °C, allowing the use of hydrogen contaminated with CO.
Evgeny N. Cherkovskiy +8 more
core +1 more source
Advanced Materials Technologies, EarlyView.Overcoming the immunogenicity challenges of enzyme‐mediated crosslinking, a flow‐through reactor utilizing SFNF‐HRP enables the continuous production of injectable hydrogels. This continuous platform ensures homogeneous crosslinking while minimizing residual HRP in the resulting hydrogels.
Ayari Miyawaki, Shinji Sakai
wiley +1 more source
International Journal of Electrochemical Science, 2017 Different contents of polyvinylidene fluoride (PVDF) nanofiber membranes were electrospun on Q345 steel surface. Nanofiber morphology was observed via scanning electron microscopy. The samples were immersed in 3.5 wt.
Yuhua Dong, Siyi Li, Qiong Zhou
doaj +1 more source
Extrusion‐Based Bioprinting of Living Bioinks for Tissue and Organ Engineering
Advanced Materials Technologies, EarlyView.Extrusion‐based bioprinting is presented as the most versatile route for fabricating living, heterogeneous tissues. Its ability to combine diverse bioinks, support matrices, and advanced printhead geometries transforms familiar constraints into powerful biofabrication opportunities.
Eric Silberman +4 more
wiley +1 more source
Microplastc filtration behavior of electrospun nanofiber membrane
, 2021 Micro/Nanoplastics (MPs/NPs) is the pollutant that needs to be removed by negatively affecting the environment. To remove MPs and NPs from water effectively, membrane technology has been considered. In this work, MP removal mechanisms from the commercial
Jaehyun Byun
core