Results 21 to 30 of about 16,712 (208)
Decoration of titania nanofibres with anatase nanoparticles as efficient photocatalysts for decomposing pesticides and phenols [PDF]
, 2012 Using a series of partial phase transitions, an effective photocatalyst with fibril morphology was prepared. The catalytic activities of these materials were tested against phenol and herbicide in water. Both H-titanate and TiO2-(B) fibres decorated with
Frost, Ray +3 more
core +2 more sources
Polymer Testing, 2022 The present study reports on a green method for the fabrication of wound dressing loaded with Pistacia atlantica extract. The oil was extracted from P. atlantica plant using a solvent extraction process.
Maryam Najafiasl +3 more
doaj +1 more source
Structure and properties of slow-resorbing nanofibers obtained by (co-axial) electrospinning as tissue scaffolds in regenerative medicine [PDF]
, 2017 With the rapid advancement of regenerative medicine technologies, there is an urgent need for the development of new, cell-friendly techniques for obtaining nanofibers—the raw material for an artificial extracellular matrix production.
Ghavami, Saeid +8 more
core +5 more sources
Veterinární Medicína, 2014 In this study, we fabricated Poly(lactide-co-glycolide)/hydroxyapatite (PLGA/HAp) nanofibres using electrospinning and evaluated their potential use for bone repair applications.
S.Y. Heo, J.W. Seol, N.S. Kim
doaj +1 more source
Catalytic CVD Synthesis of Double and Triple-walled Carbon Nanotubes by the Control of the Catalyst Preparation [PDF]
, 2005 We report the influence of catalyst preparation conditions for the synthesis of carbon nanotubes (CNTs) by catalytic chemical vapour deposition (CCVD). Catalysts were prepared by the combustion route using either urea or citric acid as the fuel. We found
Flahaut, Emmanuel +2 more
core +2 more sources
The sintering kinetics of shellfish porcelain reinforced by sepiolite nanofibres [PDF]
Royal Society Open Science, 2018 The work investigated the effect of sepiolite nanofibres on mechanical properties and sintering behaviour of shellfish porcelain. Samples of shellfish porcelain reinforced by sepiolite nanofibres were fired in an electric furnace at 1150, 1200 and 1250°C
Li Tian +5 more
doaj +1 more source
Synthesis and characterisation of controllably functionalised polyaniline nanofibres [PDF]
, 2009 A novel method for functionalising solution based polyaniline (PAni) nanofibres is reported whereby the degree of side-chain attachment can be controllably altered.
Acevedo +49 more
core +1 more source
Delamination resistant composites by interleaving bio-based long-chain polyamide nanofibers through optimal control of fiber diameter and fiber morphology [PDF]
, 2020 In this work an innovative electrospinning system is proposed that simultaneously has an adequate temperature resistance, a high increase in mode I (þ51%) and mode II (þ96%) delamination performance and can be commercially produced.
Daelemans, Lode +5 more
core +2 more sources
Nanomaterials, 2021 Alginate is a linear biodegradable polysaccharide polymer, which is bio-renewable and widely used for various biomedical applications. For the next generation of medical textiles, alginate nanofibres are desirable for their use in wound dressings that ...
Hao Lu +4 more
doaj +1 more source
International Journal of Photoenergy, 2016 Herein, we describe the synthesis of titanium dioxide (TiO2) nanoparticles by the hydrolysis and condensation of titanium tetrachloride. The resulting nanoparticles were immobilized on polyacrylonitrile (PAN) based nanofibres by an electrospinning ...
Pardon Nyamukamba +3 more
doaj +1 more source