Features of nickel alloy structure, conditions for crystallization and isolation of main and redundant phases during modification [PDF]
Омский научный вестник, 2020 The influence of modification of heat-resistant nickel-based alloys on the crystallization kinetics of alloys was established by the methods of thermal analysis.
Yu. O. Filippov +3 more
doaj +1 more source
Materials & Design, 2023 The wet phosphoric acid (WPA) process equipment is exposed to corrosive and wear conditions with aggressiveness determined by the phosphate rock chemical composition and process parameters employed.
Simbarashe Fashu, Vera Trabadelo
doaj +1 more source
An investigation into cracking in nickel-base superalloy repair welds [PDF]
, 2010 The nickel-base superalloy Rene 80 is considered very susceptible to liquation and strain-age cracking. Material in the solutionised condition is welded using the Cold Metal Transfer, or CMT process (with ductile filler alloy) and autogenously using a
Colegrove, Paul A. +3 more
core +1 more source
PREDICTION OF THE PROPERTIES OF SINGLE-CRYSTAL HEAT-RESISTANCE NICKEL ALLOYS
Nauka ta progres transportu, 2019 Purpose. This work aims to obtain predictive regression models, with which, one can adequately calculate the mechanical properties of single-crystal heat-resistant nickel alloys, without conducting preliminary experiments. Methodology.
O. A. Glotka, S. V. Haiduk
doaj +1 more source
Impact of the type of anodic film formed and deposition time on the characteristics of porous anodic aluminium oxide films containing Ni metal [PDF]
, 2011 Porous anodic films containing nickel were prepared by AC electro-deposition. The porosity of the films was controlled by using different working conditions (anodisation electrolyte, voltage, and time).
Winterton, Peter James +7 more
core +1 more source
SUPERALLOYS: AN INTRODUCTION WITH THERMAL ANALYSIS
Journal of Fundamental and Applied Sciences, 2015 Nickel based superalloys are commonly used materials in the aero industry and more specifically in the hot section of aero engines. These nickel and nickel iron based superalloys are precipitation strengthened alloys with a face centered cubic gamma ...
S. S. Raza
doaj +1 more source
Assessment of the Hot Cracking Susceptibility of the Inconel 617 Nickel-Based Alloy [PDF]
Archives of Metallurgy and Materials, 2020 Nickel alloys, despite their good strength properties at high temperature, are characterized by limited weldability due to their susceptibility to hot cracking.
J. Adamiec, N. Konieczna
doaj +1 more source
Structure and thermomechanics of selective laser melted nickel-titanium [PDF]
, 2015 NiTi has been established for applications in load-bearing implants due to its mechanical properties, which mimic the characteristics of bone better than any other known biocompatible metal or metallic alloy.
Bormann, Anna Therese
core +1 more source
Control Technology of Materials and Microstructure Properties for Steam Turbine Blades in Ultra-supercritical Power Plants [PDF]
TeshugangThe research progress and development status of ultra-supercritical steam turbine blade steels and alloys are reviewed. According to the different operating environments， blade materials can be classified into high-temperature blades and last-stage large
Zhao Jiqing +4 more
doaj +2 more sources
Friction behavior of laser cladding magnesium alloy against AISI 52100 steel [PDF]
, 2012 The use of magnesium alloys in engineering applications is becoming increasingly important as a relatively low density allows savings in energy consumption and therefore reduction in air pollution.
J.E. Masse +3 more
core +1 more source