Results 51 to 60 of about 301,552 (263)
Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing
Advanced Engineering Materials, EarlyView.The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai +6 more
wiley +1 more source
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
Advanced Engineering Materials, EarlyView.The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
Brazilian Journal of Otorhinolaryngology, 2007 INTRODUCTIONSubstances that can cause chemical burns in skin and mucosas are improper-ly packaged in beverages or medication containers, or even packages of harmless appearances. CASE PRESENTATIONA 33 year old woman dropped in her nose a product based on nitric oxide, known as “strong water” and professionally used by her husband.
Gaspar-Sobrinho, Fernando P. +2 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source
MethodsXWe searched for an extraction method that would allow a precise quantification of metal(loid)s in milligram-size samples using high-resolution graphite furnace atomic absorption spectrometry (HR-GFAAS).
Patrícia Gomes Costa +3 more
doaj +1 more source
Nanoscale Research Letters, 2018 TiO2 nanoparticles were synthesized from titanium isopropoxide by a simple peptization method using sulfuric, nitric, and acetic acids. The effect of peptizing acid on physicochemical and photocatalytic properties of TiO2 powders was studied.
Hatem A. Mahmoud +3 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.This article details the development of an artery‐on‐chip platform for in vitro arterial disease modeling and therapeutic discovery. It describes the fabrication of a fibrin biomaterial scaffold seeded with iPSC‐derived smooth muscle and endothelial cells, mimicking native artery properties. Two genetic disease models showcase the platform's ability to
Danielle Yarbrough +10 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A shape‐memory microneedle system enables reproductive hormone therapy through a single transdermal insertion. The X‐shaped device sustains follicle‐stimulating hormone release for three days, and mild heating restores the O shape to trigger burst human chorionic gonadotropin release.
Sungwoo Cho +8 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Innovative hybrid nanoassemblies installed with ferrocene, D‐α‐tocopherol succinate, and phloretin exploit the metabolic vulnerability of triple‐negative breast cancer under glucose starvation. By blocking glucose uptake, this single nanoplatform simultaneously orchestrates apoptosis, disulfidptosis, and ferroptosis to achieve synergistic and ...
Song Yi Lee +10 more
wiley +1 more source