Results 11 to 20 of about 654,186 (267)

Gain and Noise Figure Performance of Erbium-Doped Fiber Amplifiers [PDF]

open access: yesKirkuk Journal of Science, 2008
Fiber loss is a fundamental limitation in realizing long haul point–to-point fiber optical communication links and optical networks. One of the advanced technologies achieved in recent years is the advent of erbium doped fiber amplifiers (EDFAs) that has
Banaz O. Rashid, Perykhan.M. Jaff
doaj   +1 more source

Noise Performance Investigation of AlGaN/GaN HEMT With Tall Gate Stem for Millimeter-Wave LNA Application

open access: yesIEEE Journal of the Electron Devices Society, 2023
In this research, $\Gamma $ -gated AlGaN/GaN HEMTs with different layout designs and heights of gate stems were fabricated to investigate their impacts on the noise performance in the Ka-band.
Ping-Hsun Lee   +6 more
doaj   +1 more source

Noise destroys feedback enhanced figure-ground segmentation but not feedforward figure-ground segmentation

open access: yesFrontiers in Physiology, 2012
Figure-ground (FG) segmentation is the separation of visual information into background and foreground objects. In the visual cortex, FG responses are observed in the late stimulus response period, when neurons fire in tonic mode, and are accompanied by ...
August eRomeo   +4 more
doaj   +1 more source

Design of reconfigurable circularly polarised double folded inverted‐L antenna with rectangular ground plane using HFSS

open access: yesIET Networks, 2020
A novel design of reconfigurable circularly polarised antenna is proposed and developed in the present work. The circularly polarised antenna consists of two linearly polarised inverted‐L antenna elements with double‐folded arms. To improve the impedance
Padakandla Chenna Praveen Kumar   +1 more
doaj   +1 more source

Multi-Way Noiseless Signal Amplification in a Symmetrical Cascaded Four-Wave Mixing Process

open access: yesPhotonics, 2022
According to the fundamental laws of quantum optics, vacuum noise is inevitably added to the signal when one tries to amplify a signal. However, it has been recently shown that noiseless signal amplification can be realized when a phase-sensitive process
Hailong Wang   +5 more
doaj   +1 more source

A Low Power CMOS UWB LNA with Sub-1V Supply Voltage and Noise Cancellation Technique [PDF]

open access: yesمجله مدل سازی در مهندسی
Low noise amplifiers (LNA) in RF receivers are usually the first block after the antenna that amplify the signal received from the antenna with negligible noise and distortion.
Mehdi Alinejad, Emad Ebrahimi
doaj   +1 more source

Decreased noise figure measurement uncertainty in Y factor method [PDF]

open access: yesAdvances in Radio Science, 2013
Almost always noise figure is measured today by using a matched noise source delivering two different but known noise temperatures (Y factor method). In commercially available noise sources these temperatures are characterized by the excess noise ratio ...
I. Gaspard
doaj   +1 more source

FULLY OPTIMIZED ULTRA WIDEBAND RF RECEIVER FRONT END

open access: yesJordanian Journal of Computers and Information Technology, 2022
This paper proposes a novel and fully optimized Ultra-wideband rf receiver front end in UMC 180nm 1P6M CMOS process. The heterodyne architecture used in this work does not use the on-chip image reject mixer.
Rajesh Khatri, D. K. Mishra
doaj   +1 more source

Improvement of AlGaN/GaN High-Electron-Mobility Transistor Radio Frequency Performance Using Ohmic Etching Patterns for Ka-Band Applications

open access: yesMicromachines, 2023
In this paper, AlGaN/GaN high-electron-mobility transistors (HEMTs) with ohmic etching patterns (OEPs) “fabricated to improve device radio frequency (RF) performance for Ka-band applications” are reported.
Ming-Wen Lee   +4 more
doaj   +1 more source

Noise Figure Degradation in Balanced Amplifiers [PDF]

open access: yesIEEE Microwave and Wireless Components Letters, 2017
Balanced amplifiers suffer from the noise figure performance in comparison with a stand-alone amplifier even with an ideal input divider. The noise parameters degrade further with an imperfect divider. We present exact and approximate analytical results for the noise figure and noise parameters of the balanced amplifier in divider topology. Measurement
Akif Alperen Coskun, Abdullah Atalar
openaire   +3 more sources

Home - About - Disclaimer - Privacy