Results 181 to 190 of about 1,251,760 (279)
The concept of noise sensitivity: implications for noise control.
Noise & health, 2003 The term "noise sensitivity" is frequently used in many areas of noise research. However, it can be used to describe several different effects and it can be measured in different ways. In noise surveys, noise sensitivity refers to the fact that individuals differ in the annoyance produced by different sources of noise.
openaire +1 more source
Advanced Functional Materials, EarlyView.Efficient two‐photon resonant Raman scattering (TRRS) is observed in the layered perovskite (PEA)2PbI4, with the biexciton level acting as an intermediate state. TRRS undergoes two‐photon frequency shift upon input frequency tuning, persists up to 90 K, and shows clear threshold behavior and polarization selection rules.
Seung Han Shin +7 more
wiley +1 more source
Kinetic Regimes of Hydrogen Absorption in Thin Films
Advanced Functional Materials, EarlyView.Knowledge of the hydrogen incorporation mechanisms in thin layers in relation to the amount absorbed is essential to design coatings and devices compatible with hydrogen‐based technologies. A combination of simultaneous in situ methods gives detailed insight into the hydrogenation of a prototypical hydrogen absorber layer in a time‐dependent manner ...
Laura Guasco +7 more
wiley +1 more source
Unlocking Photodetection Mode Switching from a Simple Lateral Design
Advanced Functional Materials, EarlyView.A simple lateral 2D perovskite photodetector capable of switching among transient, continuous, and dual transient/continuous photoresponse modes is achieved by integrating photoconductive effects with capacitive coupling from the SiO2/Si substrate. Such light‐programmable photodetection mode switching enables triple‐channel information transmission and
Zijun (June) Yong +10 more
wiley +1 more source
Resting state network changes induced by experimental inaudible infrasound exposure and associations with self-reported noise sensitivity and annoyance. [PDF]
Sci RepForlim CG, Ascone L, Koch C, Kühn S.
europepmc +1 more source
Advanced Functional Materials, EarlyView.Developing recyclable materials for magnetic robotics that combine rapid response and self‐healing properties is challenging. Hence, this study focuses on the integration of magnetothermal nanoparticles into a dynamic sorbitol‐based vitrimer, a recyclable composite capable of remote actuation and self‐healing by magnetic heating.
Maria Weißpflog +3 more
wiley +1 more source
Sweet-spot operation of a germanium hole spin qubit with highly anisotropic noise sensitivity. [PDF]
Nat MaterHendrickx NW +7 more
europepmc +1 more source
Curvature‐Tuned Friction at Electrified Ionic Liquid Interfaces
Advanced Functional Materials, EarlyView.Graphene curvature plays a key role in friction electrotunability at single‐asperity contacts lubricated by ionic liquids. A 9 nm radius yields stronger tunability than larger radii, with distinct friction coefficients at low and high loads indicating a shift in the slippage plane.
Wei Song +6 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A MXene/PEDOT coating enables multimodal functionality and dual‐analyte detection of dopamine and serotonin in flexible microelectrode arrays while enhancing electrophysiological recording quality. The anti‐fouling, low‐impedance interface overcomes key limitations of conventional coatings, providing a robust and versatile platform to investigate the ...
Ilaria Gatti +8 more
wiley +1 more source
High‐Throughput Exfoliation of Optoelectronic‐Grade MoS2 via Turbulent‐Flow Wet Jet Milling
Advanced Functional Materials, EarlyView.A scalable wet jet milling exfoliation method is demonstrated for producing optoelectronic‐grade MoS2 nanosheets using environmentally friendly ethyl cellulose in ethanol dispersion media. Guided by fluid dynamics modeling, this approach is optimized to achieve record‐high exfoliation throughput and concentration.
Maryam Khalaj +7 more
wiley +1 more source