Results 161 to 170 of about 438,791 (295)
Design and Fabrication of Air-Coupled CMUT for Non-Contact Temperature Measurement Applications. [PDF]
Rui X +5 more
europepmc +1 more source
Microstructural evolution and hardness optimization along the cross‐section of friction stir welded AA6061/AlSi10MgMn joints, for electric vehicle battery housings, were investigated. Postweld aging between 170°C and 220°C enhances hardness uniformity within the nugget zone.
Emanuele Ghio, Emanuela Cerri
wiley +1 more source
Lateral deflection-based optimization achieves sub-picometer detection limit. [PDF]
Jiang Q, Qiao B, Ding X, Xu Y, Hu H.
europepmc +1 more source
The study investigates novel semi‐finished products made of unidirectionally arranged hemp or pineapple leaf fiber‐reinforced composites produced from different matrices. The materials are analyzed in terms of their mechanical and interfacial properties and void content.
Nina Graupner +22 more
wiley +1 more source
Transparent PEDOT:PSS/PDMS Leaf Tattoos for Multiplexed Plant Health Monitoring and Energy Harvesting. [PDF]
Ruiz-Gonzalez A, Kempson H, Haseloff J.
europepmc +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
High-Performance p-Cu<sub>2</sub>O/n-β-Ga<sub>2</sub>O<sub>3</sub> Heterojunction Barrier Schottky Diodes with Copper Contact. [PDF]
Wang X +8 more
europepmc +1 more source
Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study
This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud +7 more
wiley +1 more source
Fabrications of Fully Transparent Gallium Oxide Solar-Blind Photodetectors. [PDF]
Wang LW, Wu TY, Chu SY.
europepmc +1 more source
The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos +11 more
wiley +1 more source

