Results 201 to 210 of about 12,602,152 (306)

Non-Homogeneous Uncoupled Beam under Tip Loads

Science and Engineering of Composite Materials, 2005
Kazar, M., Rovenski, V., Grebshtein, M., Rand, O.   +3 more
doaj   +1 more source

Measuring the distillation curves of non-homogeneous fluids: method and case study of two pyrolysis oils. [PDF]

Fuel (Lond), 2017
Harries ME, McDonald AG, Bruno TJ.
europepmc   +1 more source

A parametric study of mucociliary transport by numerical simulations of 3D non-homogeneous mucus.

Journal of Biomechanics, 2016
R. Chatelin, P. Poncet
semanticscholar   +1 more source

Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading

Advanced Engineering Materials, EarlyView.
This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev, Noah‐Lean Roschlaub, Anne Jung   +2 more
wiley   +1 more source

Classification of stable solutions for non-homogeneous higher-order elliptic PDEs. [PDF]

J Inequal Appl, 2017
Harrabi A, Rahal B, Hamdani MK.
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Pneumolysin-damaged cells benefit from non-homogeneous toxin binding to cholesterol-rich membrane domains. [PDF]

Biochim Biophys Acta Mol Cell Biol Lipids, 2018
Drücker P, Bachler S, Wolfmeier H, Schoenauer R, Köffel R, Babiychuk VS, Dittrich PS, Draeger A, Babiychuk EB.   +8 more
europepmc   +1 more source

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

Advanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome, Lijie Cao, Christoph Somsen, Johannes Boes, René Hesse, Werner Theisen, Gunther Eggeler   +6 more
wiley   +1 more source

Arthroscopic treatment of non-homogeneous calcifying tendinitis of the rotator cuff. [PDF]

Springerplus, 2016
El Rassi G, Matta J, Haidamous G, Brogard P, Clavert P, Kempf JF, Irani J.   +6 more
europepmc   +1 more source

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

Advanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky, Márk Sárközi, Ibolya Zsoldos, Zoltán Weltsch   +3 more
wiley   +1 more source