Results 111 to 120 of about 606 (262)

Identification of Nonmetallic Inclusion in Steel

open access: yesTetsu-to-Hagane, 1971
Minoru SASAKI, Isamu TAGUCHI
openaire   +2 more sources

Agglomeration Behavior of Nonmetallic Particles on the Surface of Si‐Killed Liquid Steel Using HT‐CSLM: An In Situ Investigation

open access: yessteel research international, EarlyView.
The in situ agglomeration behavior of semisolid Al–silicate inclusions in Si‐killed steel is studied using high‐temperature confocal scanning laser microscopy. Particle motion and interparticle forces at the steel/argon interface are quantified and compared with a modified capillary interaction model.
Suwam Kumar   +4 more
wiley   +1 more source

Influence of Oxygen Contamination on the Genesis of Nonmetallic Inclusions in a Microalloyed Steel

open access: yessteel research international, EarlyView.
Oxygen contamination during melting of steels strongly affects the evolution of nonmetallic inclusions. Controlled remelting experiments, combined with SEM/EDS analysis and thermodynamic simulations, reveal how reoxidation promotes the transformation of alumina‐based inclusions into complex FeO–MnO oxides and other interactions.
Leandro Pianca Prandi   +2 more
wiley   +1 more source

Composition of Organosilicate Coatings High-Temperature Breakdown Products and Their Distribution in the Weld. [PDF]

open access: yesMaterials (Basel), 2022
Zhabrev L   +5 more
europepmc   +1 more source

A study on Mechanical Seepage Characteristics of Coal‐Rock Mass Under the Combined Action of Multiple Factors

open access: yesSafety Science and Technology, EarlyView.
Schematic diagram of a triaxial fluid–solid coupling device based on the mapping function. ABSTRACT In deep coal mining, the influence of temperature–pressure coupling on the mechanical properties of coal is a crucial factor inducing dynamic disasters.
Musen Gao, Heng Ma, Xiaoqi Wang, Ke Gao
wiley   +1 more source

Effect of Alloying Mode of Ca-Si Wire and FeS on Morphology of Sulfide in Low Carbon Structural Steel

open access: yesTeshugang, 2015
The effect of Ca-Si wire and FeS adding sequence on morphology of sulfide and cutting performance of low carbon structural steel (/% :0.16C, 0.65Mn, 0.25Si, 0.034S, 0.025P) is studied by using a 10 kg induction furnace.
戴雨翔   +5 more
doaj  

Electronic Modulation of Cobalt Single‐Atom Catalysts via In‐Plane and Axial Coordination Engineering for Enhanced H2O2 Electrosynthesis

open access: yesSusMat, EarlyView.
Symmetry‐breaking in‐plane and axial coordination modulates the electronic structure of cobalt single‐atom catalysts for selective two‐electron oxygen reduction (2e− ORR). In‐plane O coordination (Co–N2O2) strengthens *OOH binding and suppresses activity, whereas axially coordinated Co–N5 enriches the Co center and optimizes the dz2 orbital, weakening ...
Wenjun Zhang   +14 more
wiley   +1 more source

The Effect of Rare Earth Metals Alloying on the Internal Quality of Industrially Produced Heavy Steel Forgings. [PDF]

open access: yesMaterials (Basel), 2021
Jonšta P   +5 more
europepmc   +1 more source

Threshold Currents of Vacuum Arcs With Tungsten and Copper Cathodes

open access: yesHigh Voltage, EarlyView.
ABSTRACT This paper presents the results of an experimental study aimed at determining the threshold current for triggering a vacuum arc discharge, the probability of arc ignition and the average arc operation time depending on the current for tungsten and copper electrodes.
P. S. Mikhailov   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy