Results 271 to 280 of about 450,193 (394)

Optimization of spray operation parameters of unmanned aerial vehicle confers adequate levels of control of fall armyworm (<i>Spodoptera frugiperda</i>). [PDF]

Front Plant Sci
Liu Y, Liang X, Wu C, An X, Wu M, Zhao Z, Li Z, Chen Q.   +7 more
europepmc   +1 more source

Recent developments in spraying nozzles

, 1958
Richard J. Watts
openalex   +2 more sources

Transcript Identification Using Arrayed Hydrogels With TrapFISH

Advanced Materials Technologies, EarlyView.
TrapFISH is a novel method for high‐throughput single‐cell transcriptomics. It embeds cells in hyaluronic acid hydrogel beads and uses probe hybridization to quantify custom gene panels. By arraying hydrogels in microfluidic devices, cell barcoding is removed, enhancing scalability for studying cellular heterogeneity and rare cell states by targeting ...
David B. Morse, Zenon Toprakcioglu, Akhila Denduluri‐Marthi, James D. Brenton, Craig J. Thomas, Tuomas P. J. Knowles   +5 more
wiley   +1 more source

Numerical Study of the Reinforcing Pads Geometry of Pressure Vessels. [PDF]

Materials (Basel)
Świt G, Szczecina M.
europepmc   +1 more source

Exploring 3D Printing and Electrospinning Technologies for Advanced Porous Membrane Fabrication: A Review

Advanced Materials Technologies, EarlyView.
This paper contrasts electrospinning and 3D printing for porous membrane fabrication, evaluating their evolution, cost, resolution, mechanical traits, and scalability. While 3D printing excels in material diversity and industrial adaptability, electrospinning achieves finer resolution and thermal resilience.
Eya Kacem, Han Dong Suk, Deepalekshmi Ponnamma, Mohamed K Hassan, Alaa Hawari, Basheer A. Alshammari, Maryam Al‐Ejji   +6 more
wiley   +1 more source

The proton therapy research beamline at the Christie NHS foundation trust. [PDF]

Biomed Phys Eng Express
Henthorn NT, Warmenhoven JW, Ingram SP, Manger SP, Merchant MJ, Owen H, Mackay RI, Kirkby KJ, Taylor MJ.   +8 more
europepmc   +1 more source

CALIBRATION OF MACH 2 NOZZLE BLOCKS WITH 6% PERFORATED-WALL TEST SECTION

, 1959
W. T. Botner, H.R. Spahr, R.C. Maydew
openalex   +2 more sources

Direct Ink Writing of Carbon‐Based Electrofluids for Soft Electrical Component Manufacturing

Advanced Materials Technologies, EarlyView.
This work explores the manufacturing of Electrofluids (EFs), conductive particle suspensions that flow while maintaining conductivity, for soft electrical components. Using Direct Ink Writing (DIW), patterned EFs achieve enhanced performance, including a 800% sensitivity boost in strain gauges. Through rheological studies, a printability map is created
Niclas Hautz, Lola González‐García
wiley   +1 more source

The Influence of the Annular Nozzle's Structural Parameters on Powder Stream Convergence for Laser-Directed Energy Deposition. [PDF]

Materials (Basel)
Li B, Wang W, Li D, Liu Z, Ren Y, Wang Y, Yang G.   +6 more
europepmc   +1 more source

Studies on the Characteristics of Radial-Flow Nozzles : (4th Report, Characteristics of Pneumatic Micrometers)

, 1962
Tatsuya Hagiwara
openalex   +2 more sources