Results 81 to 90 of about 8,591 (224)
Journal of Physics: Conference Series, 2012 This study examines the effect of the electrode force condition on the nugget diameter and residual stress in spot welded high-strength steel sheets. Numerical simulations of spot welding were performed to examine the nugget diameter and residual stress.
M Iyota +5 more
openaire +1 more source
Engineering Processes for Plant‐Based Meat Analogs: Current Status and Future Outlook
Comprehensive Reviews in Food Science and Food Safety, Volume 24, Issue 6, November 2025.ABSTRACT Plant‐based meat analogs (PBMAs) have emerged as a promising alternative to conventional meat, driven by growing consumer interest in sustainability, ethical considerations, and health‐conscious diets. However, despite initial market enthusiasm, PBMAs struggle with declining consumer acceptance due to their inability to fully replicate the ...
Saqib Gulzar +4 more
wiley +1 more source
Metals, 2018 Although short-pitch resistance spot welding (RSW) significantly increases vehicle body strength, its application has been limited because of the associated shunting effect.
Jiyoung Yu
doaj +1 more source
, 2008 The importance of the Solid State Processes (SSP) has increased in the last decade due to the industry demands of improved properties of joined/surfaced materials, combined with cost reduction and energy saving.
Iordachescu, Danut +3 more
core
Marine Heatwaves Transform Coral Symbioses With Enduring Effects
Ecology Letters, Volume 28, Issue 11, November 2025.Marine heatwaves are disrupting coral–algal symbioses, yet their long‐term effects remain poorly understood. Using a decade‐long survey (2013–2023), we document a lasting transformation of symbiont assemblages, evidence of a local symbiont extinction, and indications that local human disturbance may impede symbiont recovery following a major marine ...
Alexander Van Nynatten +3 more
wiley +1 more source
Studies on fatigue behaviour of weld-bonds of Al-Mn-Mg alloy [PDF]
, 2013 In the present paper, fatigue and metallurgical behaviour of weld-bonds and adhesive bonds developed using 2 mm thick aluminium alloys namely 5052 alloy have been reported. Weld-bonds were prepared using structural adhesive (Epoxy resin) and spot welding
Dwivedi, Dheerendra, Mittal, Mayank
core
Engineering Reports, Volume 7, Issue 10, October 2025.Friction stir processing of an Al‐9.2Si‐4.9Cu‐0.7 Mg alloy effectively refined the as‐cast coarse microstructure, reducing the average grain size from ∼5.2 μm to ∼2.6 μm and promoting a uniform redistribution of eutectic Si and intermetallic phases.
Nafiseh Abassi +2 more
wiley +1 more source
Journal of Materials Research and TechnologyDissimilar materials of TC4 titanium alloy and 316L stainless steel were joined by means of resistance spot welding with nickel interlayer in different thicknesses.
Weihua Zhang +6 more
doaj +1 more source
Analysis of Fracture Modes of Resistance Spot Welded Hot-Stamped Boron Steel
Metals, 2018 Fracture modes of resistance spot welded ultra-high strength hot-stamped boron steel via lap-shear test are different from that of the traditional advanced high strength steel due to the difference in geometrical size and material property of the spot ...
Yixi Zhao, Yansong Zhang, Xinmin Lai
doaj +1 more source
Application of Alloy 718 in M-1 engine components [PDF]
Alloy 718 applied to components of M-1 rocket ...
Frick, V. +3 more
core +1 more source