Results 11 to 20 of about 2,000,505 (191)
Applied Sciences, 2020 Occlusal contact loss occasionally occurs following the placement of implant-supported fixed dental prostheses in the posterior region. This complication is caused by the change in the vertical dimension of occlusion after the recovery of mastication ...
Hai Yen Mai +3 more
doaj +2 more sources
The correction of occlusal vertical dimension on tooth wear [PDF]
Dental Journal, 2007 The loss of occlusal vertical dimension which is caused by tooth wear is necessarily treated to regain vertical dimension. Correctional therapy should be done as early possible. In this case, simple and relatively low cost therapy was performed.
Rostiny Rostiny
doaj +2 more sources
T-scan: Streamlining occlusal verification
Journal of Indian Academy of Oral Medicine and Radiology, 2023 Alteration of the vertical dimension of occlusion requires accurate diagnosis, careful case analysis, and determination of a predictive treatment plan.
Suresh Venugopalan +3 more
doaj +2 more sources
Temporomandibular Disorders Treatment with Correction of Decreased Occlusal Vertical Dimension. [PDF]
Open Access Maced J Med Sci, 2017 BACKGROUND: The term decreased occlusal vertical dimension refers to the reduced distance between two anatomical points while the teeth are in a state of occlusion.
Guguvcevski L +4 more
europepmc +4 more sources
An alternative adhesive based technique of raising the occlusal vertical dimension
Indian Journal of Dental Research, 2014 Purpose: Decimated dentitions may require raising the vertical dimension in some conditions while performing a full mouth rehabilitation treatment.
Aditi Nanda +3 more
doaj +2 more sources
Evaluation methods of occlusal vertical dimension and their clinical applications: A narrative review [PDF]
, 2022 In an extensive oral rehabilitation, determining a proper occlusal vertical dimension is a critical step and the starting point for successful treatment. Since changing the occlusal vertical dimension could be time-consuming, financially challenging, and
문홍석, 김재영, 선민지
core +1 more source
BMC Oral Health, 2023 Background The most widely used substance in the fabrication of dental prosthesis is poly (methyl methacrylate), or PMMA, and the development of biofilm is frequently associated with its use. To enhance the mechanical properties of heat-polymerized PMMA,
Esraa Yousif Taha +3 more
doaj +1 more source
Correlation of Vertical Dimensions of Soft Tissue Facial Profiles [PDF]
Al-Rafidain Dental Journal, 2010 Aims: To establish the interrelationships of linear measurements of the vertical facial heights among dif-ferent facial profiles in young Iraqi adult students.
Afrah Kh Al–Hamdany, Nagham H Kassab
doaj +1 more source
Effect of flask closure method on occlusal vertical dimension of complete upper and lower dentures [PDF]
, 2021 The movement of teeth during processing of complete dentures disturbs the harmonious occlusal scheme established at the final wax try-in stage. Aims and objectives: to investigate the effect of RS flask closure on occlusal vertical dimensions of complete
Mthethwa, Sibusiso Rockfort +3 more
core +1 more source
Estimation of occlusal vertical dimension using cephalometric angular reconstruction
Indian Journal of Dental Research, 2021 Aim: To propose a new technique, based on cephalometrics for determining the vertical dimension of occlusion (VDO). Methods and Material: Thirty-five participants in the age range of 20–22 years who met the inclusion criteria were recruited.
Dileep Nag Vinnakota +1 more
doaj +1 more source