Results 21 to 30 of about 29,376,018 (272)
IEEE Access, 2020 Three-phase gas-oil-water flow is an important type of flow present in petroleum extraction and processing. This paper reports a novel threshold-based method to visualize and estimate the cross-sectional phase fraction of gas-oil-water mixtures.
Felipe D. A. Dias +6 more
doaj +1 more source
Applied Sciences, 2021 As oil exploitation enters its middle and late stages, formation pressure drops, and crude oil degases. In production profile logging, the presence of the gas phase will affect the initial oil–water two-phase flowmeter’s flow measurement results.
Yuntong Yang +5 more
doaj +1 more source
Case Studies in Thermal Engineering, 2022 Evaluating the oil-water temperatures in flowlines is demanding mostly in deep offshore applications where flow assurance issues and dramatic heat transfer are anticipated to occur. Consequently, a 3-D mathematical model of oil-water Newtonian flow under
Nsidibe Sunday +3 more
doaj +1 more source
Numerical Simulation of Oil-water Two-phase Flow Interface Tracking
Journal of Physics: Conference Series, 2023 Abstract The insulation performance of transformer oil has a great connection with the stable operation of power systems, and transformer oil will inevitably be mixed with water and other impurities in the actual operation. To explore the mechanism of the influence of suspended water droplets on the insulation performance of transformer ...
Hua Hu +6 more
openaire +1 more source
Geofluids, 2022 In the modern petroleum industry system, oil-water two-phase flows exist widely. Among them, the total flow rate of mixture fluid in a horizontal well is difficult to obtain due to the phase segregation caused by gravity. Therefore, it is a difficult and
Xin Zhang +3 more
doaj +1 more source
IEEE Access, 2019 Water accumulation in low-lying areas of product oil pipelines always leads to corrosion damage of pipelines. Predicting the law of product oil carrying water can provide reference for the optimization of pipeline operation parameters and corrosion ...
Tao Zhang +4 more
doaj +1 more source
The Influence on Response of a Combined Capacitance Sensor in Horizontal Oil–Water Two-Phase Flow
Applied Sciences, 2019 In the process of production logging interpretation, a water cut is one of the key factors to obtain the oil phase content in the oil well. In order to measure the water cut of the horizontal oil⁻water two-phase flow with low yield, the response ...
Lei Li +7 more
doaj +1 more source
The Recognition Algorithm of Two-Phase Flow Patterns Based on GoogLeNet+5 Coord Attention
Micromachines, 2023 The two-phase flow in a microchannel consists of liquid–liquid and gas–liquid material components. The automatic recognition of flow patterns using deep learning approaches has been emerging.
Jinsong Zhang +2 more
doaj +1 more source
Two-phase flow meter for determining water and solids volumetric flow rate in vertical and inclined solids-in-water flows [PDF]
Multiphase flow can be defined as the simultaneous flow of a stream of two or more phases. Solids-in-water flow is a multiphase flows where solids and liquid are both present. Due to the density differences of the two phases, the results for such flow is
Muhamedsalih, Yousif
core +3 more sources
Gamma radiation methods for clamp-on multiphase flow metering [PDF]
, 2008 The development of a cost-effective multiphase flow meter to determine the individual phase flow rates of oil, water and gas was investigated through the exploitation of a single clamp-on gamma densitometer and signal processing techniques.
Blaney, S.
core +3 more sources