Results 71 to 80 of about 271,048 (306)

A Review of Progress in Oil-Water Two-Phase Flow Research

open access: yesFrontiers in Sustainable Development
This paper summarises the current state of research on oil-water two-phase flow, covering flow pattern classification, experimental studies, and model calculations. Common flow patterns and their influencing factors are introduced, and the conversion of different flow types is analyzed.
Yesai Li   +3 more
openaire   +1 more source

Two-phase flow of gas-liquid mixtures on horizontal helical pipes [PDF]

open access: yes, 2007
The aim of this study was to investigate hydrodynamic two -phase (namely water and air) fluid flow characteristics in helical pipes of low amplitude and straight pipes of the same internal-diameter and constructional material: the results for the two ...
Adedigba, A. G
core  

Atomized Oxidative Polymerization as a 3D Printing Platform for Binder‐Free, Bulk Conductive Polymer Architectures

open access: yesAdvanced Functional Materials, EarlyView.
Co‐delivery of electrosprayed EDOT and oxidant enables bulk oxidative polymerization during layer‐by‐layer fabrication, creating stable, highly conductive 3D PEDOT structures. This Atomized Oxidative Polymerization (AOP) overcomes the surface deposition‐only and matrix‐limited conductivity of conventional Vapor Phase Polymerization (VPP) and PEDOT:PSS ...
Tazdik Patwary Plateau   +2 more
wiley   +1 more source

Review of Thermally Activated Twisted Coiled Polymer Actuators: A Materials Science Perspective

open access: yesAdvanced Functional Materials, EarlyView.
Thermally activated twisted and coiled polymer actuators (TCPAs) combine lightweight design, large deformation, and scalable fabrication for soft robotic and wearable applications. This review connects polymer structure, processing history, helix geometry, and thermomechanical characterization to actuator performance, highlighting current challenges in
Nadja Schenk   +3 more
wiley   +1 more source

Effect of Crude Oil-Water Two-Phase Flow on Pump Performance

open access: yesEngineering and Technology Journal, 2009
An experimental study of pump performance (i.e. head, discharge, power, etc.) was achieved by using a centrifugal pump with crude oil-water two-phase flow. The crude oil used was from Sherao oil field in Kirkuk (Iraq) with a density of 838 kg/m3, dynamic viscosity of 6.0 cP and surface tension of 0.027 N/m at a temperature of 25oC.
Banipal N. Yaqob, Ihsan F. Abbas
openaire   +2 more sources

Complex network analysis of phase dynamics underlying oil-water two-phase flows [PDF]

open access: yesScientific Reports, 2016
AbstractCharacterizing the complicated flow behaviors arising from high water cut and low velocity oil-water flows is an important problem of significant challenge. We design a high-speed cycle motivation conductance sensor and carry out experiments for measuring the local flow information from different oil-in-water flow patterns.
Zhong-Ke Gao   +4 more
openaire   +2 more sources

Myrcene‐Based Tailored Co‐Polymers as Active Pharmaceutical Excipients: Bio‐Based Solutions for Mucoadhesive Excipients

open access: yesAdvanced Functional Materials, EarlyView.
Mucoadhesive amphiphilic block and statistical copolymers were synthesized via Reversible Addition–Fragmentation Chain Transfer polymerization from bio‐sourced myrcene and polyethylene glycol methacrylate. The resulting polymers exhibit narrow molar‐mass distributions, high regioselectivity, well‐defined microstructures, and tend to self‐assemble into ...
David Gintsburg   +9 more
wiley   +1 more source

Oil/water separation in a novel cyclone separator [PDF]

open access: yes, 2007
Conventional bulk oil-water separation is performed in large gravity separators that take up large areas and potentially contain large volumes of hazardous material.
Stone, Andrew Colin
core  

Modeling of Two-Phase Flow in Rough-Walled Fracture Using Level Set Method

open access: yesGeofluids, 2017
To describe accurately the flow characteristic of fracture scale displacements of immiscible fluids, an incompressible two-phase (crude oil and water) flow model incorporating interfacial forces and nonzero contact angles is developed.
Yunfeng Dai   +3 more
doaj   +1 more source

Oil Phase Velocity Measurement of Oil-Water Two-Phase Flow with Low Velocity and High Water Cut Using the Improved ORB and RANSAC Algorithm

open access: yesMeasurement Science Review, 2020
Velocity is an important parameter for fluid flow characteristics in profile logging. Particle tracking velocimetry (PTV) technology is often used to study the flow characteristics of oil wells with low flow velocity and high water cut, and the key to ...
Han Lianfu   +5 more
doaj   +1 more source

Home - About - Disclaimer - Privacy