Results 151 to 160 of about 29,867 (309)

Influence of Direct Saponification Conditions on Sterol Yield and Composition of the Unsaponifiable Fraction of the Microalga Isochrysis galbana and the Seaweed Ascophyllum nodosum

open access: yesJournal of the American Oil Chemists' Society, EarlyView.
ABSTRACT Saponification is a key step for recovering the unsaponifiable fraction (USF) of lipids, which contains bioactive sterols, tocopherols, and carotenoids. This study optimized direct saponification conditions (50–300 g L−1 KOH; 60°C–100°C) to recover sterol‐rich USFs from the microalga Isochrysis galbana and the brown seaweed Ascophyllum nodosum,
Mina Zareie, Suzanne M. Budge
wiley   +1 more source

Impact of Galactolipids and Phosphatidylcholine on the Stability of Microalgal Oil‐In‐Water Emulsions

open access: yesJournal of the American Oil Chemists' Society, EarlyView.
ABSTRACT Microalgal oil is a sustainable source of omega‐3 polyunsaturated fatty acids. However, it is very sensitive to lipid oxidation, especially in emulsions. While the presence of phospholipids and galactolipids in microalgal oil can influence its oxidation, their impact in oil‐in‐water emulsion is not yet fully understood. This study investigates
Weiwei Sun   +2 more
wiley   +1 more source

Synergistic Effect on Enhanced Oil Recovery in High Salinity Carbonate Reservoirs Using a Novel PEI‐Functionalized Carbon Nanotube Nanocomposite

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Enhancing oil recovery (EOR) in mature reservoirs is hindered by high interfacial tension (IFT) and oil‐wet rock formations, especially under harsh, high‐salinity conditions. This study aims to overcome these limitations by synthesizing a novel carbon nanotube nanocomposite covalently grafted with polyethylenimine and non‐covalently ...
Mohamed Abu Shuheil   +8 more
wiley   +1 more source

Granular Bed Filtration of Coal Pyrolysis Gas: Effects of Media Reactivity on Dust Removal and Products

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Granular bed filtration is a promising technology for removing dust from high‐temperature coal pyrolysis gas. In this work, the reactivity of coal pyrolysis products over ceramsite, char, ultrastable Y‐type (USY) zeolite, and quartz particles was compared.
Shuaiqiang Yang   +4 more
wiley   +1 more source

Hybrid Inertial–Centrifugal Gas–Liquid Separator: CFD‐Driven Optimization Using Coupled Discrete Phase and Wall‐Film Modeling With Response Surface Methodology

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Efficient removal of liquid aerosols from compressed gas streams is essential in chemical and energy processes. Conventional separators relying on a single mechanism (inertial or centrifugal) struggle to capture both fine and coarse droplets simultaneously.
Son Ung Kang   +3 more
wiley   +1 more source

Advancing Environmental Sustainability: The Role of Artificial Intelligence in Monitoring, Predicting, and Controlling Sulfur Dioxide Emissions

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Air pollution from sulfur dioxide (SO2) emissions poses significant threats to environmental sustainability, public health, and climate change efforts. Despite advances in monitoring and regulatory frameworks, traditional methods often fall short in accuracy, scalability, and efficiency.
Turkan Kopac
wiley   +1 more source

Dicarboxymethyl Cellulose‐Based Mixed‐Matrix Membrane Adsorbers: Preparation, Characterization, and Protein Retention Performance

open access: yesJournal of Applied Polymer Science, EarlyView.
Dicarboxymethyl cellulose is incorporated, for the first time, into a polyethersulfone membrane. The functional membranes are prepared using dimethyl isosorbide through combined non‐solvent and vapor‐induced phase separation. The resulting membranes exhibit porous structures and protein‐retention potential, highlighting the potential of this cellulose ...
Diana Gago   +7 more
wiley   +1 more source

Polyurethane Foams From a Triblock Copolymer Polyol With CO2‐Derived, High‐Tg Polycarbonate Segments

open access: yesJournal of Applied Polymer Science, EarlyView.
Polyurethane foam (PUF) properties are tuned by incorporating polyol with 0–15 wt% CO2‐derived poly(cyclohexene carbonate) (PCHC) segments (Tg = 104°C). Network PUFs are synthesized using CO2‐derived triblock copolymer polyol with PCHC hard segments and a polycaprolactone soft segment.
Yen‐Wen Huang   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy