Results 121 to 130 of about 19,781,428 (312)
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
Advanced Engineering Materials, EarlyView.A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.PUF/ENB microcapsules were synthesized based on a sequential factorial design and incorporated into an epoxy matrix. Their anticorrosive action, associated with the self‐healing mechanism, demonstrated that the addition of microcapsules to the coating improved anticorrosive performance compared to pure epoxy coatings, particularly when the encapsulate ...
Vandicleya Alves Moreira +6 more
wiley +1 more source
Inflation Targeting and the Inflation Process: Lessons from an Open Economy [PDF]
In an open economy inflation-targeting framework, whether policy makers should target aggregate or non-traded inflation depends on the structural relationships in the economy. This paper shows that in a small empirical model of the Australian economy, it
Guy Debelle, Jenny Wilkinson
core
Hysteresis in an Open Economy Model
Scottish Journal of Political Economy, 2000 This paper explores the properties of an open economy model in which real exchange rate overshooting has a permanent impact on the rate of unemployment via a hysteresis mechanism. The magnitude of this effect depends on the slope of the short‐run Phillips curve, the speed with which expectations adjust in the labour market, and on the speed with which ...
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Commitment, Discretion and Fixed Exchange Rates in an Open Economy
, 2004 Compares optimal exchange rate policy under discretion and commitment in a New Keynesian open economy ...
MONACELLI, TOMMASO
core
Advanced Engineering Materials, EarlyView.A thermoplastic PMMA‐based photoresin enables high‐resolution DLP printing followed by solvent‐vapor smoothing. The treatment reduces staircase‐induced surface roughness from 2.33 µm to 129 nm and increases visible‐light transmittance from approximately 30% to 80%, providing a route toward transparent PMMA components for rapid prototyping and non ...
Rozhin Heydarpour +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Particle morphology controls the balance between printability and electrical connectivity in low‐temperature AgCu/Ag metallization pastes. Flake‐shaped AgCu particles form extended low‐resistance contacts, whereas spherical particles favor processability at high metal loading. Fine Ag particles further tune void filling and conductive‐network formation
O. Mhirsi +3 more
wiley +1 more source
Optimal Monetary Policy in a Small Open Economy Under Segmented Asset Markets and Sticky Prices [PDF]
This paper studies optimal monetary policy in a two-sector small open economy model under segmented asset markets and sticky prices. We solve the Ramsey problem under full commitment, and characterize the optimal monetary policy in a version of the model
Ruy Lama, Juan Pablo Medina
core