Results 81 to 90 of about 193,064 (281)
All-fiber focused optical vortex array generator [PDF]
EPJ Web of ConferencesWe report a focused optical vortex array (FOVA) generator prepared by printing a Dammann spiral zone plate on the composite fiber facet using femtosecond laser two-photon polymerization.
Wang Yuji +4 more
doaj +1 more source
Optical frequency tripling with improved suppression and sideband selection [PDF]
, 2011 Journal Article, Impact factor:3.749A novel optical dispersion tolerant millimetre-wave radio-over-fibre system using optical frequency tripling technique with enhanced and selectable sideband suppression is demonstrated.
Laurêncio, Paula +3 more
core
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Applications of polymer optical fibre grating sensors to condition monitoring of textiles [PDF]
, 2009 Fibre Bragg gratings (FBGs) in polymer optical fibres (POFs) have been used to measure the strain in a woven textile. FBGs in both POFs and silica optical fibres were attached to a woven textile specimen, and their performance characterised.
Chambers, A. R. +8 more
core +3 more sources
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
Advanced Engineering Materials, EarlyView.The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
, 1997 We compare the performance of dispersion-shifted-fibre (DSF) and semiconductor-optical-amplifier (SOA) based phase conjugators for a 10 Gb/s non-return-to-zero system with respect to conversion efficiency, noise figure and distortion.
Cole, M.J. +4 more
core +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Results in OpticsThis paper presents the development and deployment of a multi-point fiber Bragg grating (FBG) sensor system for precise temperature monitoring along the vacuum chamber walls of dipole and Pinger magnets in Indus-2, a synchrotron radiation source.
J. Kumar +8 more
doaj +1 more source