Results 221 to 230 of about 1,847,375 (374)

Machine Learning Techniques for Optical Performance Monitoring From Directly Detected PDM-QAM Signals

open access: yesJournal of Lightwave Technology, 2017
Jakob Thrane   +5 more
semanticscholar   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

An OSNR Monitoring Scheme based on Mean and Variance Value of Signal Amplitude

open access: yesGuangtongxin yanjiu
【Objective】Optical Signal-to-Noise Ratio (OSNR) is an important criterion for evaluating the performance of communication systems. For optical fiber communication systems, stable operation can only be ensured if the OSNR at the receiver end exceeds the ...
CHEN Fang   +6 more
doaj  

Mesoporous Silica Microspheres by Super‐Fast Alkaline Etching of Micrometer‐Sized Stöber Particles

open access: yesAdvanced Engineering Materials, EarlyView.
Microscale silica particles are prepared along with a modified, scalable Stöber synthesis using the continuous addition of tetraethoxy silane to an ethanolic solution of ammonia with KCl. Etching with hydroxide ions at 95 °C gave porous analogs within minutes. Monodisperse particles are isolable in high yield after precipitation in ethanol.
Adrian Vaghar   +2 more
wiley   +1 more source

Comparative Study of Experimental Methods for Measuring Thermal Properties of 100Cr6 Steel Powders

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the thermal properties of 100Cr6 steel in both bulk and powder forms. Measuring the very low thermal conductivity typically exhibited by powders poses significant challenges. To address this, two novel measurement techniques—temperature gradient and finite laser pulse response—are introduced and evaluated by comparison with the ...
Junsheng Zhuo   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy