Results 121 to 130 of about 863,347 (299)

Cavity-Enhanced Ultrafast Transient Absorption Spectroscopy

open access: yes, 2015
We present a new technique using a frequency comb laser and optical cavities for performing ultrafast transient absorption spectroscopy with improved sensitivity.
Allison, Thomas K.   +2 more
core   +1 more source

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

open access: yesAdvanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky   +5 more
wiley   +1 more source

Optical Spectroscopy of Microcavities

open access: yes, 1997
Microcavities, such as microspheres, possess morphology-dependent resonances (MDR’s). In this chapter light coupling mechanisms to MDR’s is examined. The novel mechanism of excitation of the microsphere with an optical fiber coupler (OFC) provides spatially and spectrally selective, as well as enhanced light coupling to the MDR’s, when compared with ...
Serpengüzel, Ali   +3 more
openaire   +2 more sources

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

open access: yesAdvanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé   +5 more
wiley   +1 more source

Optical spectroscopy study on single crystalline LaFeAsO

open access: yes, 2010
Millimeter-sized single crystals of LaFeAsO were grown from NaAs flux and the in-plane optical properties were studied over a wide frequency range. A sizable electronic correlation effect was indicated from the analysis of the free-carrier spectral ...
Chen, Z. G.   +3 more
core   +1 more source

Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies

open access: yesAdvanced Engineering Materials, EarlyView.
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo   +3 more
wiley   +1 more source

DFT Study of Functionalized Benzoxazole-Based D–π–A Architectures: Influence of Ionic Fragments on Optical Properties and Their Potential in OLED and Solar Cell Devices

open access: yesMolecules
This theoretical work investigates the linear (absorption and emission) and nonlinear (first hyperpolarizability and TPA) optical properties of donor–π–acceptor (D–π–A) molecular architectures based on functionalized benzoxazoles, with potential ...
Edwin Rivera   +4 more
doaj   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Optical Spectroscopy of Comets

open access: yesBulletin de la Société Royale des Sciences de Liège
Comets are pristine remnants of the Solar system, composed of dust and ice. They remain inactive and undetectable for most of their orbit due to low temperatures. However, as they approach the Sun, volatile materials sublimate, expelling dust and creating a visible coma.
Aravind, K., Ganesh, Shashikiran
openaire   +2 more sources

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

open access: yesAdvanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy