Results 31 to 40 of about 35,955 (312)
KONTRUKSI PT-Symmetry MULTI DIMER PADA DOMAIN TAK HINGGA
Parity-Time Symmetry, or abbreviated as -Symmetry, can be explained as the propagation of an optical beam in two bound waveguides, where one waveguide experiences strengthening and the other waveguide experiences weakening, with each intensity having the
Maya Sari Syahrul +2 more
doaj +1 more source
Slow-light and evanescent modes at interfaces in photonic crystal waveguides: optimal extraction from experimental near-field measurements [PDF]
We develop a systematic approach for simultaneous extraction of the dispersion relations and profiles of multiple modes in periodic waveguides though a special global optimization procedure applied to near-field electric field measurements in the ...
Ha, S. +23 more
core +1 more source
Properties of Multimode Optical Epoxy Polymer Waveguides Deposited on Silicon and TOPAS Substrate [PDF]
The paper reports on the fabrication and characterization of multimode polymer optical waveguides. Epoxy polymer EpoCore was used as the waveguide core material and EpoClad was used as a cladding and cover protection layer.
V. Prajzler +3 more
doaj
Properties of Large Core Polymer Optical Bend Waveguides [PDF]
We report about properties of large core plastic planar optical bend waveguides. The dimensions of the waveguides were to be compatible with the commonly used plastic optical fiber with diameter 750 µm and the bend radii of the waveguides varied from 30 ...
V. Prajzler, M. Knietel, P. Jasek
doaj
The cascaded integration of optical waveguides with third-order optical nonlinearity ( $\chi ^{(3)}$ susceptibilitiy) with lithium niobate (LiNbO $_{3}$) waveguides is demonstrated on the same chip.
Amirmahdi Honardoost +9 more
doaj +1 more source
ARRAW: anti-resonant reflecting acoustic waveguides
Development of acoustic and optoacoustic on-chip technologies calls for new solutions to guiding, storing and interfacing acoustic and optical waves in integrated silicon-on-insulator systems.
M K Schmidt +3 more
doaj +1 more source
PROBLEM TO BE SOLVED: To satisfy the transparency and heat resistance and further to fulfill the workability and optical isotropy which have been incompatible with heat resistance so far by using a specified polyurethane contg. an asymmetric spiro ring as the optical core and/or optical clad. SOLUTION: A polyurethane shown by the formula and contg.
openaire +3 more sources
Design, fabrication, and optimization of tantalum pentoxide (Ta2O5) waveguides to obtain low-loss guidance at a wavelength of 1070 nm are reported.
Wilkinson, James S. +5 more
core +1 more source
Waveguiding and photoluminescence in Er3+-doped Ta2O5 planar waveguides [PDF]
The optimization of erbium-doped Ta2O5 thin film waveguides deposited by magnetron sputtering onto thermally oxidized silicon wafer is described. Optical constants of the film were determined by ellipsometry.
OTON NIETO, CLAUDIO JOSE +9 more
core +1 more source
In situ loss measurement of direct UV written waveguides using integrated Bragg gratings
The propagation loss of a direct UV-written silica-on-silicon waveguide is measured using an elegant nondestructive method. The technique uses integrated Bragg grating structures, which are observed from opposing launch directions to obtain information ...
Rogers, H.L. +9 more
core +1 more source

