Results 51 to 60 of about 128,617 (284)
A statistical study into parameter effects on the coverage of organic coatings on rounded steel edges [PDF]
, 2022 S.186-194The relationships between edge rounding parameters and edge coverage of organic coating systems are systematically investigated. Three organic coating systems for highly corrosive environments are tested.
Marquardt, T. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study reports the development of antibacterial ceramic scaffolds derived from natural bovine bone. The bones were processed through sequential boiling and hydrogen peroxide treatment to remove organic matter, producing porous, mineral‐rich scaffolds.
Mohamad Hassan Taherian +6 more
wiley +1 more source
International Journal of Electrochemical Science, 2019 Carrier density (CD) was adopted to investigate the corrosion process of acrylic polyurethane-coated galvanized steel in 3.5% NaCl solution by using the Mott-Schottky (M-S) analysis technique.
L. Lu, T.L. Lu, M.Z. Ding, J. Gao
doaj +1 more source
Alexandria Engineering Journal, 2023 High−velocity oxygen−fuel (HVOF) sprayed WC−Cr3C2−Ni/CNTs coatings were prepared on 430 stainless steel, and then were sealed with sol–gel aluminum phosphate (inorganic sealant) and silicone resin (organic sealant) by ultrasound−assisted sealing ...
Dongcheng Mei +4 more
doaj +1 more source
A spectroscopic study of the degradation of polyurethane coil coatings. [PDF]
, 2012 PhDThe degradation of polyurethane (PU) coil coatings were studied with step scan phase modulation photo-acoustic (SS-PM-PA) FTIR, confocal Raman mapping (CRM) and scanning electron microscopy (SEM). PU coatings were oven cured for 30 seconds to reach
Zhang, Ying
core
Alkali-activated cements for protective coating of OPC concrete [PDF]
, 2015 Recent innovations have led to the development of alkali-activated coating materials to replace organic coating and repairing materials for protecting and strengthening existing concrete structures, particularly for those under rigorous conditions.
H. Wang, Z. Zhang, Wang, H., Zhang, Z.
core +1 more source
Advanced Engineering Materials, EarlyView.This work shows that the mechanical performance of multimaterial digital light processing (DLP) printed thermoset composites is governed by resin compatibility and interfacial design rather than spatial patterning alone. Brittle and ductile resin combinations produced premature interfacial failure, while graded interfaces and mechanically compatible ...
Ahmed M. H. Ibrahim +3 more
wiley +1 more source
International Journal of Electrochemical Science, 2013 Electrochemical impedance spectroscopy (EIS) of an organic coating system in 3.5% NaCl solution was measured and a new parameter k(f) named changing rate of phase angle at high frequency is extracted directly from Bode plots.
Antao Xu +4 more
doaj +1 more source
Migration and segregation phenomena of a silicone additive in a multilayer organic coating [PDF]
, 2017 The migration and segregation of a minor silicone containing additive in a multilayer, organic coating system has been investigated by X-ray photoelectron spectroscopy (XPS) and time-of-flight secondary ion mass spectrometry (ToF-SIMS).
Lowe, C +3 more
core +2 more sources
Advanced Engineering Materials, EarlyView.This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer +4 more
wiley +1 more source