Results 41 to 50 of about 768,811 (301)
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
International Journal of Aviation, Aeronautics, and AerospaceWith the rapid evolution of commercial space markets in the new space era, satellite design philosophy is transitioning from "performance supremacy" toward "cost-effectiveness priority." This research concentrates on solar arrays, a critical component ...
Hongyi Zhang, Liang Su
doaj +1 more source
, 2010 The Aerospace Section of the Engineering Division encourages communication and cooperation among information professionals concerned with aerospace, aeronautical and related technologies.
Ramachandran, Hema
core +2 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Robust multi-fidelity design of a micro re-entry unmanned space vehicle [PDF]
, 2011 This article addresses the preliminary robust design of a small-scale re-entry unmanned space vehicle by means of a hybrid optimization technique. The approach, developed in this article, closely couples an evolutionary multi-objective algorithm with a ...
Aupoix B. +9 more
core +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Carbon nanotubes for epoxy Nanocomposites: a review on recent developments [PDF]
, 2012 Carbon nanotubes (CNTs) are one of the strongest and stiffest engineering fibres. Due to their unique combination of chemical and physical properties at an incredibly small size, they possess great potential to be used as nanofillers for many structural ...
Inam, Fawad, Luhyna, Nataliia
core
Principles for aerospace manufacturing engineering in integrated new product introduction [PDF]
, 2013 This article investigates the value-adding practices of Manufacturing Engineering for integrated New Product Introduction. A model representing how current practices align to support lean integration in Manufacturing Engineering has been defined.
Beadle, Chris +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source