Results 61 to 70 of about 11,997 (226)
Evaluations on Performance of Overcurrent Protection Relay Based on Relay Operation
International Journal of Electrical Engineering and Applied Sciences, 2019 Protection system plays an important role in detecting the presence disorders and may prevent damage caused interference. This can improve the reliability of the system to maintain continuity of supply to the load.
MOHD SHAHRIEEL MOHD ARAS
doaj
Impact of converter interface type on the protection requirements for DC aircraft power systems [PDF]
, 2012 The utilization of converter interfaces has the potential to significantly alter the protection system design requirements in future aircraft platforms.
Burt, Graeme +3 more
core +1 more source
Energy Science &Engineering, Volume 14, Issue 1, Page 266-280, January 2026.This study establishes a hybrid microgrid model integrating a Doubly Fed Induction Generator (DFIG), a photovoltaic (PV) array, and a battery energy storage system, and proposes a coordinated control framework. The DFIG regulates DC‐bus voltage through the grid‐side converter and performs maximum power tracking via the rotor‐side converter, while the ...
Chunyan Li +4 more
wiley +1 more source
System for Measuring and Protecting the Anode Current of TH2103A Klystron
南方能源建设[Introduction] The 3.7 GHz high-power TH2103A klystrons are widely used in the tokamak experimental device. To simplify the HV power supply system (removing the vacuum tetrode in the anode modulation), a power supply mode based on voltage division mode ...
Yali CHEN +6 more
doaj +1 more source
Energies, 2019 As the development of renewable distributed generations (DGs) is growing rapidly, the autonomous self-healing microgrid had emerged as an effective solution for integrating renewable DGs in the distribution networks.
Kheng Heong Oon +4 more
doaj +1 more source
Energies, 2020 The uses of high-temperature superconducting (HTS) cables pose a challenge of power system protection since the impedance of the HTS cable is varied during fault conditions. The protection systems should be designed properly to ensure the reliability and
Thai-Thanh Nguyen +3 more
doaj +1 more source
Circuit provides overcurrent protection to push-pull amplifier [PDF]
, 1967 Circuit in push-pull amplifier limits the current flowing to a predetermined level and provides that overcurrent in one half of the amplifier turns off the other ...
Skorra, D. J.
core +1 more source
Energy Science &Engineering, Volume 14, Issue 1, Page 364-376, January 2026.Nonlinear Power Transfer Matrix Model for Power Control and Modeling of PMSG‐Wind Turbines ABSTRACT This paper presents the Lyapunov stability scheme based nonlinear power transfer matrix (NLPTM) model for controlling and modeling the permanent magnet synchronous generator (PMSG) based wind turbine.
Muhammad Ali Bijarani +5 more
wiley +1 more source
Engineering ProceedingsOvercurrent protection is a fundamental aspect of power system protection and is widely utilised in distribution networks. The increasing integration of renewable energy sources (RESs) into the conventional power system has introduced operating ...
Le Nam Hai Pham +2 more
doaj +1 more source
Demonstration of adaptive overcurrent protection using IEC 61850 communications [PDF]
, 2013 This paper contains a description of an adaptive protection scheme that has been implemented and demonstrated in a hardware in the loop simulation environment using commercially available protection hardware and IEC 61850 communications.The ...
Blair, Steven Macpherson +4 more
core