Results 111 to 120 of about 678,149 (297)

On the effect of oxygen partial pressure on the chromium distribution coefficient in melt-grown ruby crystals

open access: yes, 2011
Small ruby crystals were grown by the Czochralski technique in different atmospheres and their actual chromium content was analysed by a wet chemical method.
Bertram, Rainer   +2 more
core   +1 more source

PBF‐LB/M of Ti‐6Al‐4V: High‐Pressure Solution Treatment and Aging for Applications in a Sustainable Aerospace

open access: yesAdvanced Engineering Materials, EarlyView.
Additive manufacturing (AM) allows great geometric freedom for lightweight components. As parts are progressively optimized exploiting potentials in AM leading in smaller material cross sections, high pressure solution treating and aging (STA) treatments show an enormous potential for strongly improving material properties.
Mika León Altmann   +4 more
wiley   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

open access: yesAdvanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé   +5 more
wiley   +1 more source

Influence of Sample Preparation and Processing Procedures on the Thermal Diffusivity of MgO‐C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan   +4 more
wiley   +1 more source

Probeinto of optimum oxygen partial pressure prediction threshold of ulcer healing in patients with lower extremities atherosclerosis disease with foot ulcers

open access: yesHuli yanjiu, 2019
Objective:To explore the optimum threshold of oxygen partial pressure for ulcer healing in patients with lower extremities atherosclerosis disease,LEAD;and foot ulcer.Methods:A total of 25 cases of LEAD patients with foot ulcer were followed up for 3 ...
王希罕, 张川林, 牟绍玉
doaj  

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Pengaruh Terapi Oksigen Menggunakan Non-Rebreathing Mask Terhadap Tekanan Parsial CO2 Darah pada Pasien Cedera Kepala Sedang

open access: yesJurnal Kesehatan Andalas, 2014
AbstrakTekanan parsial CO2sangat berpengaruh terhadap aliran darah otak (ADO) dan tekanan intra kanial. Latarbelakang penelitian ini adalah bahwa dalam teori tekanan gas campuran John Dalton dinyatakan bahwa jika salah satu tekanan gas dalam campuran gas
Hendrizal .   +2 more
doaj  

Consumed by Abdominal Distention

open access: yes
Arthritis Care &Research, EarlyView.
Abimbola Fadairo‐Azinge   +3 more
wiley   +1 more source

Tribological Performance of 60NiTi Alloy Under Varying Contact Conditions and Elevated Temperatures in Linear Reciprocating Sliding

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy