Results 121 to 130 of about 3,438,442 (401)

Study on the Detection of Single and Dual Partial Discharge Sources in Transformers Using Fiber-Optic Ultrasonic Sensors

open access: yesPhotonics
Partial discharge is a fault that occurs at the site of insulation defects within a transformer. Dual instances of partial discharge origination discharging simultaneously embody a more intricate form of discharge, where the interaction between the ...
Feng Liu   +3 more
doaj   +1 more source

Bio-inspired Printed Monopole Antenna Applied to Partial Discharge Detection

open access: yesItalian National Conference on Sensors, 2019
A new, bio-inspired printed monopole antenna (PMA) model is applied to monitor partial discharge (PD) activity in high voltage insulating systems.
J. D. Cruz   +6 more
semanticscholar   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

3D Simulation of Partial Discharge in High Voltage Power Networks [PDF]

open access: yes, 2019
Open accessPartial discharge (PD) events arise inside power cables due to defects of cable’s insulation material, characterized by a lower electrical breakdown strength than the surrounding dielectric material.
Duffy, A. P.   +2 more
core  

Advanced partial discharge testing of 540V aeronautic motor fed by SiC inverter under altitude conditions [PDF]

open access: yes, 2017
The present paper reports non-electrically intrusive partial discharge investigations on an aeronautic motor fed by SiC inverter drive under variable environmental conditions.
Abadie, Cédric   +2 more
core   +1 more source

Residual Stress States in Microstructurally Graded PBF–LB/M Austenitic Steel Components

open access: yesAdvanced Engineering Materials, EarlyView.
This study examines microstructurally graded 316L rectangular tube profiles fabricated via PBF–LB/M using a dual‐laser system. A 1 kW top‐hat and a 400 W Gaussian laser create distinct grain sizes and crystallographic texture. Mechanical properties are linked to microstructural evolution driven by processing conditions.
Nico Möller   +5 more
wiley   +1 more source

Investigation of Iron‐Aluminide‐Like Phase Composition in Complex Concentrated Fe32Cu12Ni11Ti16Al29 Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
This work reveals the phase composition and quantitative morphology analysis of precipitation‐hardened Fe32Cu12Ni11Ti16Al29 complex‐concentrated alloy. The precipitates are shown to have a high coherency. Morphology transition between sphere, cuboidal, and elongated morphology is observed. Finally, the overaging behavior is captured using microhardness.
Rostyslav Nizinkovskyi   +4 more
wiley   +1 more source

Partial discharge analysis of defective three-phase cable

open access: yes, 2011
Power distribution cable networks represent a dynamic and complex challenge with regard to the issues of maintenance and providing a reliable, high quality supply of electrical power.
Cornish, N.   +6 more
core  

Partial Discharge Detection Using a Spherical Electromagnetic Sensor

open access: yesItalian National Conference on Sensors, 2019
The presence of a partial discharge phenomenon in an electrical apparatus is a warning signal that could determine the failure of the insulation system, terminating the service of the apparatus and/or the network.
P. Romano, A. Imburgia, G. Ala
semanticscholar   +1 more source

On the Deformation Behavior of Metastable CrMnNi Steels Processed by Directed Energy Deposition in Different Temperature Regimes

open access: yesAdvanced Engineering Materials, EarlyView.
In the present study, metastable CrMnNi steels with varying chemical compositions and a concomitantly altered stacking fault energy are processed via directed energy deposition and afterwards tested via tensile tests at different temperatures. The present study shows the influence of the manufacturing process on the elemental deformation mechanisms for
Julia Richter   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy