Results 211 to 220 of about 2,933,444 (411)
PARTICLE ACCELERATOR DIVISION SUMMARY REPORT FOR OCTOBER 1, 1957 THROUGH APRIL 15, 1958
openalex +1 more source
BDSIM: An accelerator tracking code with particle-matter interactions [PDF]
L. Nevay+10 more
semanticscholar +1 more source
Laboratory protocols for producing thin‐film pH electrodes for sterilized single‐use technologies have been successfully developed into a semiautomated workflow, with higher throughput and precision of membrane thickness. Accuracies are within 0.05 pH units versus ground truth, and uncertainty analysis reveals the largest sources of error to be derived
Bingyuan Zhao+4 more
wiley +1 more source
Broad-band chopper for a CW proton linac at Fermilab
Requirements and technical limitations to the bunch-by-bunch chopper for the Fermilab Project X are discussed.Comment: 3 pp. Particle Accelerator, 24th Conference (PAC'11) 2011. 28 Mar - 1 Apr 2011.
Gianfelice-Wendt, E.+4 more
core
Assessing the Microstructure of SnBiZn Alloys during Semisolid Treatment
The development of Sn‐based alloys for semisolid processing is crucial for Industry 4.0. This study investigates Sn40Bi and Sn40Bi2Zn alloys, revealing that Zn refines Sn‐rich globules by pinning dendrite boundaries. Bi saturation occurs at 60 min, while Zn enhances globule microhardness at 90 min through solid solution strengthening.
Carolina de Siqueira Simioli+2 more
wiley +1 more source
This study presents a 3D representative volume element‐based simulation approach to predict mesoscopic residual stress and strain fields in silicon solid solution‐strengthened ductile cast iron. By modeling phase transformation kinetics with an enhanced Johnson–Mehl–Avrami–Kolmogorov model, the effects of varying cooling rates on residual stresses are ...
Lutz Horbach+6 more
wiley +1 more source
Plasmas in Particle Accelerators: The Warm-Beam Equilibria [PDF]
J.W.K. Mark, L. Smith
openalex +1 more source
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen+4 more
wiley +1 more source