Results 171 to 180 of about 54,484 (206)
Some of the next articles are maybe not open access.
Crushing of particles in idealised granular assemblies
Journal of the Mechanics and Physics of Solids, 2009zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Russell, A.R. +2 more
openaire +2 more sources
The maximum crushing capacity of a wood particle crusher
Advanced Powder Technology, 1988The relationship between the increasing rate of holdup and the feed rate were examined. From the results, the maximum crushing capacity was defined as the maximum feed rate where holdup did not change with time and remained at a constant value.The effect of the hammer rotation speed, ω, and the reduction ratio, Dv/dv, on the maximum crushing capacity ...
Hiromu ENDOH +3 more
openaire +1 more source
Effects of Particle Crushing in Stress Drop-Relaxation Experiments on Crushed Coral Sand
Journal of Geotechnical and Geoenvironmental Engineering, 2010Stress relaxation and stress drop-relaxation tests have been performed to complement a test series performed to study strain rate, creep, and stress drop-creep effects on crushed coral sand. Drained experiments with constant effective confining pressure of 200 kPa were performed in which triaxial specimens of crushed coral sand were loaded to initial ...
Poul V. Lade +2 more
openaire +1 more source
Dynamic inter-particle friction of crushed limestone surfaces
Tribology International, 2017Abstract The frictional characteristics of granular materials are of major interest in research and practice in geotechnical and petroleum engineering. In this study, micromechanical sliding experiments were conducted at the contacts of crushed limestone grains in a range of vertical forces from 0.5 to 5.0 N capturing the frictional response during a
K. Senetakis, C.S. Sandeep, M.C. Todisco
openaire +1 more source
Peridynamics simulation of particle crushing
2019By means of Peridynamic simulations [1], we investigate the breakage mechanics of particles under he action of external forces. The particles have an internal texture composed of a distribution of cleavages (micro-cracks), representing the natural inhomogeneity of the particles.
Blanc, Nicolas +4 more
openaire +1 more source
Crushing strength of irradiated Triso coated fuel particles
Journal of Nuclear Materials, 1983Abstract The crushing strength of irradiated Triso coated fuel particles was studied. The crushing tests were carried out on 17 kinds of irradiated samples and on 10 kinds of unirradiated samples for purposes of comparison. It was observed that the crushing strength decreased after compact fabrication as well as after irradiation.
Kazuo Minato +4 more
openaire +1 more source
A peridynamic investigation on crushing of sand particles
Géotechnique, 2019Particle crushing underpins important macroscopic behaviour of granular materials such as yielding, deformation, dilatancy, failure, mobility and packing features. The crushing condition and crushing pattern have commonly been examined for particles subjected to uniaxial loadings.
F. Zhu, J. Zhao
openaire +2 more sources
The Particle Size Analysis of Crushed Products
Proceedings of the Institution of Mechanical Engineers, 1950An examination is made of two particle size analyses which are typical of two categories of crushed products. One example represents material reduced in a hammer mill; subjected to indiscriminate reduction, it contains a preponderance of smaller sizes, and this is characteristic also of ball mill products and the small particles in the products of jaw,
openaire +1 more source
CLASSIFICATION OF SOLID PARTICLE CRUSHING EQUIPMENT
Our raw materials that reach production are mostly hard and large in size. This causes us a lot of inconvenience in production, and at the same time, it also causes the quality of our products to decrease. Therefore, after the arrival of our raw materials, they are first washed, crushed and similar operations are carried out and washed to the ...openaire +2 more sources