Mixing Performance of the Modified Tesla Micromixer with Tip Clearance
Micromachines, 2022 A passive micromixer based on the modified Tesla mixing unit was designed by embedding tip clearance above the wedge-shape divider, and its mixing performance was simulated over a wider range of the Reynolds numbers from 0.1 to 80. The mixing performance
Makhsuda Juraeva, Dong-Jin Kang
doaj +1 more source
Evaluation of flow characteristics that give higher mixing performance in the 3-D T-mixer versus the typical T-mixer [PDF]
, 2014 This document is the Accepted Manuscript of the following article: Cesar Augusto Cortes-Quiroz, Alireza Azarbadegan, and Mehrdad Zangeneh, ‘Evaluation of flow characteristics that give higher mixing performance in the 3-D T-mixer versus the typical T ...
Azarbadegan, Alireza +2 more
core +2 more sources
Reconfigurable metamaterial structure for 5G beam tilting antenna applications [PDF]
, 2020 In this paper, we propose a metamaterial (MTM) structure with a reconfigurable property designed to operate at the millimetre-wave (mm-wave) spectrum. Four switches are used to achieve the reconfigurable property of the MTM with two configurations. These
A. Majid, Huda +7 more
core +2 more sources
Micromachines, 2017 Microfluidic devices have attracted increasing attention in the fields of biomedical diagnostics, food safety control, environmental protection, and animal epidemic prevention.
Gaozhe Cai +3 more
doaj +1 more source
Design of micromixers using CFD modelling [PDF]
, 2005 The effect of various geometrical parameters of a grooved staggered herringbone micromixer on the mixing performance has been investigated using Computational Fluid Dynamics.
Anson +25 more
core +3 more sources
Optimal control-based inverse determination of electrode distribution for electroosmotic micromixer [PDF]
, 2017 This paper presents an optimal control-based inverse method used to determine the distribution of the electrodes for the electroosmotic micromixers with external driven flow from the inlet.
Shizhi Qian +5 more
core +3 more sources
Experimental study of helical milling on CFRP (carbon fibre reinforced polymer) for the hole making process [PDF]
, 2012 Generate borehole by helical milling process may be used effectively since accurate location of the hole may be secured by means of the feed screw graduations.
Jamil, M. F. M. +5 more
core +1 more source
Photoresponsive Passive Micromixers Based on Spiropyran Size‐Tunable Hydrogels
Macromolecular Rapid Communications, 2017 AbstractMicrofluidic devices allow the manipulation of fluids down to the micrometer scale and are receiving a lot of attention for applications where low volumes and high throughputs are required. In these micro channels, laminar flow usually dominates, which requires long residence times of the fluids, limiting the flow speed and throughput.
Jeroen ter Schiphorst +6 more
openaire +4 more sources
A fast passive and planar liquid sample micromixer
Lab Chip, 2004 A novel microdevice for passively mixing liquid samples based on surface tension and a geometrical mixing chamber is presented. Due to the laminar flow regime on the microscale, mixing becomes difficult if not impossible. We present a micromixer where a constantly changing time dependent flow pattern inside a two sample liquid plug is created as the ...
Melin, Jessica +4 more
openaire +4 more sources
Concentration-adjustable micromixer using droplet injection into a microchannel
, 2018 A novel micromixing technique that exploit a thrust of droplets into the mixing interface is developed. The technique enhances the mixing by injecting immiscible droplets in a mixing channel and the methodology enables a control of the mixing level ...
Motosuke, Masahiro +2 more
core +1 more source