Results 1 to 10 of about 88,007,393 (199)
Peak-to-Average-Power-Ratio (PAPR) reduction in WiMAX and OFDM/A systems [PDF]
EURASIP Journal on Advances in Signal Processing, 2011 A peak to average power ratio (PAPR) reduction method is proposed that exploits the precoding or beamforming mode in WiMAX. The method is applicable to any OFDM/A systems that implements beamforming using dedicated pilots which use the same beamforming ...
Svantesson Thomas +3 more
doaj +6 more sources
PAPR reduction in LTE network using both peak windowing and clipping techniques
Journal of Electrical Systems and Information Technology, 2019 Multicarrier technique orthogonal frequency division multiplexing (OFDM) modulation is a solution to provide high-speed and secured data transmission requirement in 4G technologies. Peak-to-average power ratio (PAPR) is one major drawback in OFDM system.
Richard Musabe +5 more
doaj +3 more sources
Peak-to-Average Power Ratio (PAPR) Reduction by Pulse Shaping Using the K-Exponential Filter
IEICE Transactions on Communications, 2010 A K-exponential filter is derived and utilized for pulse shaping to reduce peak to average power ratio (PAPR) without intersymbol interference (ISI). While keeping the same bandwidth, the frequency responses of the filters vary with different values of the parameter k.
Yung-Fang Chen
exaly +3 more sources
IEEE Open Journal of the Communications SocietyIn this paper, we propose new methods for reducing the peak-to-average power ratio (PAPR) for downlink massive multiple-input multiple-output (MIMO) along with orthogonal frequency division multiplexing. We develop the PAPR reduction method based on peak
Jun Saito +2 more
doaj +3 more sources
CLIPPING TECHNIQUES FOR PAPR REDUCTION IN FBMC/OQAM SYSTEM OVER DOUBLY-SELECTIVE CHANNELS
Journal of Engineering and Sustainable Development, 2021 One of the major disadvantages of Filter Bank Multicarrier (FBMC) is high Peak-to-Average Power Ratio (PAPR) of transmitted signal. As a result, nonlinear power amplifier (PA) properties, considerable out-of-band and the in-band distortion types take ...
Noor Q. Lateef, Fadhil S. Hasan
doaj +3 more sources
Testbed for a Novel Approach to Minimizing the PAPR of 5G Systems
IEEE Access, 2023 The generalized frequency division multiplexing (GFDM) system has attracted the interest of the research community due to its unique characteristics such as high spectrum efficiency, low latency, and high transmission rate.
Sivaprasad Valluri +4 more
doaj +1 more source
Journal of Electrical Systems and Information Technology, 2022 Orthogonal frequency division multiplexing (OFDM) continues to be the most preferred signal-multiplexing scheme for high-speed data communication. However, OFDM signals are known to have the problem of high peak-to-average power ratio (PAPR), especially ...
Stephen Kiambi +2 more
doaj +1 more source
PAPR Reduction in MIMO-OFDM via Power Efficient Transmit Waveform Shaping
IEEE Access, 2022 In this paper we revisit the long-standing problem of peak-to-average power ratio minimization in MIMO-OFDM systems, with a new angle of approach on a well-known scheme.
Antti Arvola +3 more
doaj +1 more source
Performance Analysis of the Two-Piecewise Linear Companding Technique on Filtered-OFDM Systems
IEEE Access, 2021 Filtered orthogonal frequency division multiplexing (F-OFDM) is one of the most prominent waveform candidates when it comes to fifth-generation (5G) wireless communication and beyond.
Mishal Al-Gharabally +2 more
doaj +1 more source
Low-Complexity Selective Mapping Methods for Multicarrier Faster-Than-Nyquist Signaling
IEEE Access, 2020 Multicarrier faster-than-Nyquist (MFTN) signaling is a high spectral efficiency transmission scheme, which is promising in the future communication. One of the major problems of MFTN signaling is high peak-to-average power ratio (PAPR).
Biao Cai, Aijun Liu, Xiaohu Liang
doaj +1 more source