Results 61 to 70 of about 9,472 (221)
The sixth generation (6G) wireless networks are used to provide a large coverage, and also this generation needed to support different emerging applications in harsh areas with higher user equipment mobility. For the above case, a new modulation technique called orthogonal time–frequency space (OTFS) modulation has emerged as a promising technique to ...
Ephrem Gelamite Demere +2 more
wiley +1 more source
Given the explosive increase in mobile data traffic, the wireless communication system of today and beyond has to be able to offer both high spectral efficiency and energy efficiency (EE) under challenging propagation environments such as deep indoor, high‐speed mobility, or tunneling. This work presents an improved structure of doing SIMO SC‐FDMA–DMWT
Mohammed Aboud Kadhim +3 more
wiley +1 more source
Comparing GFDM With OFDM for Use in 6G Communication From a New Perspective
The most important challenges facing 6G communication systems are the large amount of data and low latency as compared to previous generations. Therefore, it has become necessary to use advanced technologies to meet the requirements of 6G wireless communication systems.
Mohammed Azher Therib +2 more
wiley +1 more source
Flexible Multi-Group Single-Carrier Modulation: Optimal Subcarrier Grouping and Rate Maximization
Orthogonal frequency division multiplexing (OFDM) and single-carrier frequency domain equalization (SC-FDE) are two commonly adopted modulation schemes for frequency-selective channels. Compared to SC-FDE, OFDM generally achieves higher data rate, but at
Lie, Joni Polili +3 more
core +1 more source
A low complexity SI sequence estimator for pilot-aided SLM–OFDM systems [PDF]
Selected mapping (SLM) is a well-known method for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems.
Adegbite, Saheed A. +2 more
core +1 more source
ABSTRACT In this article, we provide a novel, expanded, and adapted pruning approach for the Simplified Volterra Series (SVS) model that makes it applicable to a wider range of Power Amplifiers (PAs). The proposed Modified SVS (MSVS) model is then applied in a Digital Predistortion (DPD) architecture to linearize a 25 W Gallium Nitride (GaN) RF PA.
Haithem Rezgui +3 more
wiley +1 more source
Performance Analysis of MIMO Links With Non‐Isolated Active Antenna Arrays
ABSTRACT In this paper, we analyze the performance of non‐isolated active arrays in a multiple‐input multiple‐output (MIMO) system. When ferromagnetic‐type isolators are removed in the transmitter (Tx) chains, the antenna mutual coupling will dynamically change the load impedance seen by the power amplifiers (PAs) at their outputs, which subsequently ...
Jiayu Hou +3 more
wiley +1 more source
Impact of reformed RM Encoded data on PAPR of Multicode CDMA under MSK
In this research work, the effect of Reformed Reed Muller Encoded Data (RRMED) on Peak to Average Power Ratio (PAPR) of Multicode Code Division Multiple Access (MC-CDMA) systems was studied under Minimum Shift Keying (MSK) modulation. Simulation studies
S. Rizwan-ul- Hasan +2 more
doaj
Peak-to-average power ratio reduction based on cross-correlation in OFDM systems [PDF]
Two of the most important techniques of Peak-to-average power ratio (PAPR) reduction in orthogonal frequency division multiplexing (OFDM) systems are Partial Transmit Sequence PAPR (PTS-PAPR) and Cross-Correlation-PTS.
Hashim, Shaiful Jahari +5 more
core +1 more source
Energy‐Aware Protocol Design and Evaluation of the PHY Layer in Satellite IoT
ABSTRACT Direct‐to‐satellite communication for the Internet of Things (IoT) has attracted significant interest from both the scientific community and major telecommunications players. The integration of satellite connectivity in smartphones and IoT devices promises a transformative impact on critical applications such as environmental monitoring, asset
Simon Heine +2 more
wiley +1 more source

