Results 161 to 170 of about 3,833 (190)
Proceedings of the 15th International Congress on Circumpolar Health. [PDF]
Int J Circumpolar Health, 2013 europepmc +1 more source
Characterization of Friction Loss in Pelton Turbine
, 2010 Beucher, Yannick +2 more
openaire +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Rancang Bangun PLTMH Menggunakan Turbin Pelton
Jurnal Teknik Informatika dan Elektro, 2022Energi air merupakan energi yang sangat melimpah di Indonesia oleh karena itu dapat dimanfaatkan menjadi beberapa pembangkit listrik yang salah satunya yaitu pembangkit listrik Tenaga Mikrohidro (PLTMH) yang merupakan pembangkit listrik berskala kecil (kurang dari 100 kW) dengan memanfaatkan tenaga (aliran) air sungai sebagai sumber energi.
Royb Fatkhur Rizal +3 more
openaire +1 more source
2016
In mountain areas where plenty of water is available, Pelton turbines are often designed with two to maximum six injectors (Fig. 19.1). Of concern in the design is the minimum displacement, i.e., the offset angle between two adjacent injectors. The jet is allowed to enter the bucket only when the bucket is relieved from the loading by the upstream jet.
openaire +1 more source
In mountain areas where plenty of water is available, Pelton turbines are often designed with two to maximum six injectors (Fig. 19.1). Of concern in the design is the minimum displacement, i.e., the offset angle between two adjacent injectors. The jet is allowed to enter the bucket only when the bucket is relieved from the loading by the upstream jet.
openaire +1 more source
Working Principle of Pelton Turbines
2016In hydropower plants with Pelton turbines, the available hydraulic energy exists as potential energy, which is measured in the form of the geodetic height difference between the upper level of water in the reservoir and the turbines in the machine house of a lower altitude.
openaire +1 more source
Hydraulic Design of Pelton Turbines
2016For the hydraulic design of a Pelton turbine, the net head on the pressure side and the desired flow rate are two fundamental parameters. They determine the available hydraulic power supply and therefore the size of the turbine. The design of a Pelton turbine starts with the dimensioning of the Pelton wheel, the choice of the rotational speed, and the ...
openaire +1 more source
Numerical analyses of a cavitating pelton turbine
2013Erosive wear of hydro turbine runners is a complex phenomenon, which depends upon many parameters and which leads to a decrease of the performance in time and/or in extreme cases to the rotor mechanical failure. Consistently, the study of this wearing process is an important step to improve the impeller design, to avoid or minimize the rise of ...
PAVESI, GIORGIO +3 more
openaire +2 more sources
Flow friction theorem of Pelton turbine hydraulics
Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2007The flow friction in the rotating buckets of a Pelton turbine influences the system efficiency in both the direct and indirect ways. The direct influence is determined by the friction, which directly drives or retards the bucket motion and thus determines the power output. The indirect way is determined by the changes of relative flow and the pressure
openaire +1 more source
Eksperimentalno određivanje karakteristika modela Pelton turbine [PDF]
, 2016 This thesis presents the research on the performance characteristics of a model of Pelton turbine. The characteristics observed are ideal and real power of the turbine model and ideal and real efficiency of the turbine model in relation to two parameters: angular velocity of the turbine model, and the non-dimensional ratio of tangential speed of ...
openaire
Analysis performance of mini pelton turbine
AIP Conference Proceedings, 2022Nailul ’Atifah +3 more
openaire +1 more source