Corrosion behaviour of nitrided ferritic stainless steels for use in solid oxide fuel cell devices
, 2020 Plasma nitriding was applied to ferritic stainless steel substrates to improve their performances as interconnects for solid oxide fuel cell devices. The samples underwent electrical conductivity test and SEM/EDS, TEM/EDS, environmental-SEM analyses. The
Bianco, M. +7 more
core +1 more source
Understanding the build-up of a Technological Innovation System around Hydrogen and Fuel Cell Technologies [PDF]
This study provides insight into the development of hydrogen and fuel cell technologies in the Netherlands (1980-2007). This is done by applying a Technological Innovation System (TIS) approach.
Marko P. Hekkert +2 more
core
Transient non-isothermal model of a polymer electrolyte fuel cell
, 2007 In this paper we present a one-dimensional transient model for the membrane electrode assembly of a polymer-electrolyte fuel cell. In earlier work we established a framework to describe the water balance in a steady-state, non-isothermal cathode model ...
Harvey, D. +3 more
core +1 more source
Fuel cells : state of the art [PDF]
, 2009 Publication CIMNEThis report pretends to explain the state of the art of fuel cells and the applications focused on aviation, such as unmanned aerial vehicles (UAV).
Jarauta Arabí, Àlex, Pons Prats, Jordi
core +1 more source
Research progress in composite graphite bipolar plate materials and properties
Cailiao gongchengBipolar plates play a role in electron transfer, gas distribution, water management, supporting membrane electrode assembly in the proton exchange membrane fuel cell (PEMFC) and is also a key component to ensure low cost of fuel cell stack. In this paper,
LI Tuanfeng +8 more
doaj +1 more source
Recent Developments in Mems-Based Micro Fuel Cells [PDF]
, 2006 Micro fuel cells ($\mu$-FC) represent promising power sources for portable applications. Today, one of the technological ways to make $\mu$-FC is to have recourse to standard microfabrication techniques used in the fabrication of micro electromechanical ...
Gauthier-Manuel, B., Pichonat, T.
core +4 more sources
, 2012 We present here the results of our density-functional-theory-based calculations of the electronic and geometric structures and energetics of Se and O adsorption on Ru 93- and 105-atom nanoparticles. These studies have been inspired by the fact that Se/Ru
Stolbov, Sergey, Zuluaga, Sebastian
core +1 more source
SIMULATION OF POROSITY AND PTFE CONTENT IN GAS DIFFUSION LAYER ON PROTON EXCHANGE MEMBRANE FUEL CELL PERFORMANCE [PDF]
Journal of Engineering Science and Technology, 2016 Numerous research and development activities have been conducted to optimize the operating parameters of a proton exchange membrane fuel cell (PEMFC) by experiments and simulations. This study explains the development of a 3D model by using ANSYS FLUENT
NUR H. MASLAN +3 more
doaj
Fuel-cell performance of multiply-crosslinked polymer electrolyte membranes prepared by two-step radiation technique [PDF]
, 2009 A multiply-crosslinked polymer electrolyte membrane was prepared by the radiation-induced co-grafting of styrene and a bis(vinyl phenyl)ethane (BVPE) crosslinker into a radiation-crosslinked polytetrafluoroethylene (cPTFE) film.
Alkan Gursel, Selmiye +9 more
core
The Influence of Heat Input Ratio on Electrical Power Output of a Dual-Core Travelling-Wave Thermoacoustic Engine [PDF]
This paper presents an analytical and experimental investigation of an electricity generator that employs a two-stage looped tube travellin -wave thermoacoustic prime-mover to deliver acoustic power from heat energy, a loudspeaker to extract electricity ...
Hann, D. +3 more
core