Results 211 to 220 of about 193,312 (259)

Chemical grafting of waste polystyrene with acrylic acid and subsequent amine functionalization to enhance polystyrene modified bitumen characteristics. [PDF]

Sci Rep
Abo-Shanab ZL, Elsharaky EA, El-Tabey AE, Ragab AA.   +3 more
europepmc   +1 more source

Wetting Behavior of Acrylate Hot-Melt Adhesive on Polyester Fabric Substrates and Its Influence on Adhesion Performance. [PDF]

Polymers (Basel)
Shi H, Qian J, Shi Y.
europepmc   +1 more source

<i>Trichoderma</i> as a biological control agent against <i>Colletotrichum</i>-associated plant diseases: current insights and future perspectives. [PDF]

Plant Signal Behav
Adhitya R, Miranti M, Jefferson TA, Albert M, Joshi RC, Mispan MS, Prismantoro D, Abdullah NS, Alizadeh M, Hermawan W, Doni F.   +10 more
europepmc   +1 more source

Progress in immunotherapy for <i>Helicobacter pylori</i> infections. [PDF]

Front Cell Infect Microbiol
Zhong W, Yang Y, Cao P, Luo LX, Wang K.
europepmc   +1 more source

Symbiont-mediated mechanisms of insecticide resistance in insects. [PDF]

J Insect Sci
Lv C, Xia Q, Yan S.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Penetration resistance of aluminium foam

International Journal of Vehicle Design, 2005
The resistance of aluminium foam against projectile penetration has been studied experimentally and analytically and the results are presented in this paper. The penetration depth of a rigid, flat-nosed projectile into an aluminium foam target was measured at various impact velocities between 20 m/s and 120 m/s.
S R Reid, Q M Li
exaly   +3 more sources

Predissolution and Postdissolution Penetration Resistance

Journal of Geotechnical and Geoenvironmental Engineering - ASCE, 2013
AbstractMineral dissolution is a common chemomechanical digenetic process in geological systems. The penetration resistance in sediments that have experienced dissolution is studied using a laboratory-scale cone penetration test device and a calibration chamber. Variables include the initial sediment density and mass fraction of soluble grains. Results
J CARLOS Santamarina, Minsu Cha, Santamarina J CARLOS   +2 more
exaly   +2 more sources

PENETRATION RESISTANCE OF RUBBER VULCANIZATES

Rubber Chemistry and Technology, 2020
ABSTRACT Aspects of penetration resistance of rubber compounds have been studied by developing a quasi-static test. The effects of indenter material and design, nature and dosage of fillers, and crosslinking density were investigated. Indenter material was found to have a negligible contribution to the penetration characteristics of the rubber ...
Anil K. Bhowmick, Subhabrata Saha, Anshul Baral, Kumar Vineet, Arup S. Deuri, Dilip M. Vaidya   +5 more
openaire   +1 more source