Results 11 to 20 of about 2,570 (205)
IEEE Access, 2018 Compared with conventional drill, an ultrasonic drill can break into rocks under lower weight on bit and lower power, which is more suitable to sample in low gravity environment for deep-space exploration. However, the ultrasonic drill cannot remove rock
Yinchao Wang +5 more
doaj +1 more source
The rock breaking capability analyses of sonic drilling
Journal of Low Frequency Noise, Vibration and Active Control, 2021 Sonic drilling technology uses the longitudinal vibration of a drill string to realize fast and effective drilling. By setting the top and bottom boundary conditions of the drill string during drilling, a dynamic model of flexible sonic string percussive
Yonghang Qian +4 more
doaj +1 more source
Intelligent optimization for a full-sized PDC bit with composite percussive rock breaking drilling
Journal of Intelligent Construction, 2023 Intelligent drilling has obtained a lot of attention in mining engineering, oil and gas production, and tunnelling engineering. The optimization of drilling parameters is one of the most important technologies of intelligent drilling while determining ...
Liping Li +7 more
doaj +1 more source
Experimental research into the effect of some operation factors and rock properties on the rate of penetration [PDF]
, 2020 Purpose. The purpose of this research is to investigate the effect of weight on bit (WOB), rotary speed (RPM), and some rock properties on the rate of penetration (ROP). Methods.
Ali, Mahrous A.M. +4 more
core +1 more source
Experimental studies of the resultant contact forces in drillbit-rock interaction [PDF]
, 2014 Peer ...
Ajibose, Olusegun Kolawole +2 more
core +1 more source
Development of engineering solutions for air drilling at Dulisminsk oilfield, Irkutsk oblast [PDF]
, 2015 The article presents the analysis of disastrous mud loss achieved during casing at Dulisminsk oil and gas condensate field (DOGCF) and comparative evaluation of geological structure of DOGCF and Naryksko-Ostashkinsk area of Kemerovo oblast, where the ...
Boyarko, Yuriy Leontievich +2 more
core +2 more sources
Impact Dynamics of a Percussive System Based on Rotary-Percussive Ultrasonic Drill
Shock and Vibration, 2017 This paper presents an impact dynamic analysis of a percussive system based on rotary-percussive ultrasonic drill (RPUD). The RPUD employs vibrations on two sides of one single piezoelectric stack to achieve rotary-percussive motion, which improves ...
Yinchao Wang +5 more
doaj +1 more source
Shock and Vibration, 2017 Based on an optimized lunar regolith coring bit (LRCB) configuration, the load characteristics of rotary-percussive drilling of lunar rock simulant in a laboratory environment are analyzed to determine the effects of the drilling parameters (the ...
Peng Li +3 more
doaj +1 more source
High Efficiency Drilling Methods for Through Beds Hole in Underground Coal Mine
Meikuang Anquan, 2020 Considering the drilling efficiency problem encountered by crossing holes in underground coal mine, the paper divided roof and floor rock stratum into three grades in order to facilitate the study of technology in underground coal mine: high hard rock (4≤
DOU Xuqian
doaj +1 more source
Energy Reports, 2021 In the present study, a 3D FEM of compound percussive system considering a loading–unloading cycle was employed to simulate the dynamic single-cutter-rock interaction.
Yumei Li +4 more
doaj +1 more source