High Voltage, Volume 10, Issue 6, Page 1474-1485, December 2025.ABSTRACT Electric locomotives on the horizon will integrate SiC inverters, promising quicker switching and lower losses than traditional setups. However, in addition to the steep rising edge, the inverter‐fed motor drive system faces challenges such as high common‐mode voltage (CMV) and high motor terminal surge voltage swing rate (dv/dt).
Bo Gao +4 more
wiley +1 more source
Finite-Time Chaos Suppression of Permanent Magnet Synchronous Motor Systems
Entropy, 2014 This paper considers the problem of the chaos suppression for the Permanent Magnet Synchronous Motor (PMSM) system via the finite-time control. Based on Lyapunov stability theory and the finite-time controller are developed such that the chaos behaviors ...
Yi-You Hou
doaj +1 more source
Full‐order observer design for quadratic port‐controlled Hamiltonian systems
Asian Journal of Control, Volume 27, Issue 6, Page 2724-2739, November 2025.Abstract The full‐order observer design problem for a particular class of port‐controlled Hamiltonian systems is approached in this paper. The proposed full‐order observer scheme belongs to the structure preserving class of dynamic estimators as it preserves the natural stability properties of the approached class of systems that are useful for the ...
Michael Rojas +2 more
wiley +1 more source
A fault diagnosis method of turn-to-turn short circuit of Permanent Magnet Synchronous Motor (PMSM) based on deep learning [PDF]
, 2022 Jiahao Wang, Liuxuan Wei, Manyi Wang
openalex +1 more source
Quality and Reliability Engineering International, Volume 41, Issue 6, Page 2290-2305, October 2025.ABSTRACT This study introduces a novel calibration strategy for the linear Kalman filter (LKF) fusion application in condition monitoring, specifically utilizing accelerated aging data. Unlike the existing literature that often focuses on complex nonlinear Kalman filter variants, this research delves into the calibration of LKF.
Emre Genis, Duygu Bayram Kara
wiley +1 more source
Modal Analysis and Structure Optimization of Permanent Magnet Synchronous Motor
IEEE Access, 2020 Permanent magnet synchronous motors are the core components of electric vehicles and widely used in the field of electric vehicles. The existence of vibration will reduce the operating efficiency and service life of the motor, which is the key factor to ...
Jian Zhao +6 more
doaj +1 more source
A New Fixed Switching Frequency Direct Torque Controlled PMSM Drives with Low Ripple in Flux and Torque [PDF]
, 2011 Direct Torque Control (DTC) has gained popularity for development of advanced motor control due to its simplicity and offers fast instantaneous torque and flux controls.
Jidin, A. (Auzani) +2 more
core +4 more sources
Low-cost, high-resolution, fault-robust position and speed estimation for PMSM drives operating in safety-critical systems [PDF]
, 2019 In this paper it is shown how to obtain a low-cost, high-resolution and fault-robust position sensing system for permanent magnet synchronous motor drives operating in safety-critical systems, by combining high-frequency signal injection with binary Hall-
De Donato, Giulio +4 more
core +1 more source
Initial rotor position estimation and sensorless direct torque control of surface-mounted permanent magnet synchronous motors considering saturation saliency [PDF]
, 2008 For a practical direct torque-controlled (DTC) permanent magnet synchronous motor (PMSM) drive system, the information of the initial rotor position, which is usually obtained by a mechanical position sensor, is essential for starting under the full load.
Guo, YG, Yan, Y, Zhu, JG
core +1 more source
Miniature high speed compressor having embedded permanent magnet motor [PDF]
, 2011 A high speed centrifugal compressor for compressing fluids includes a permanent magnet synchronous motor (PMSM) having a hollow shaft, the being supported on its ends by ball bearing supports. A permanent magnet core is embedded inside the shaft.
Acharya, Dipjyoti +7 more
core +2 more sources